My vials crashing?

[dbow196]

I have a few viles of test-e I'm saving and noticed a cloudly residue at the bottom of the vile. I shake them up and it goes away, but after a while sitting for a while the cloud (white in color) comes back.

From that can one tell if the gear is no good/too old? What's the best way to tell? This is UG stuff.

I've heard that if you heat up the vile it could save it, if so how do you do that?

 

[dsade]

What's the concentration of it (mg/ml)?

Might be oversaturated.

 

[dbow196]

What's the concentration of it (mg/ml)?

Might be oversaturated.

300mg/ml

It's about 2-3 years old.

 

[dsade]

300mg/ml

It's about 2-3 years old.

That's a little high, IMO. Most Test-E's run 200-250mg/ml.

Try a hot water bath before injecting. You will increase the saturability of the oil and allow for smoother injection.

 

[jvb20]

try baking your gear put it in a frying pan with water heat at around 250 degrees for 10-15 min make sure to put a pin in the stoper to vent the air

jvb20

 

[Zero V]

try baking your gear put it in a frying pan with water heat at around 250 degrees for 10-15 min make sure to put a pin in the stoper to vent the air

jvb20

and when your done do you yell "BAM!!!"

 

[jvb20]

and when your done do you yell "BAM!!!"

what are you talking about???

jvb20

 

[ATOMLABS]

try baking your gear put it in a frying pan with water heat at around 250 degrees for 10-15 min make sure to put a pin in the stoper to vent the air

jvb20

i agree heating it up should fix the problem...

 

[mixedup]

what are you talking about???

jvb20

it's from a popular cooking show the cook always yells BAM when he puts fancy ingredients in

 

[jvb20]

it's from a popular cooking show the cook always yells BAM when he puts fancy ingredients in

oh i see i thought he was talking like it would break witch it wont..

jvb20

 

[Zero V]

oh i see i thought he was talking like it would break witch it wont..

jvb20

yeah sorry lol. most people know about that guy, there is even a character on Futurama that makes front of the BAM part.

 

[Teknic]

The microwave works fine if you need to warm a vial; vent it with a pin of course and hit it for 6-7 seconds, shake it, and another 5 seconds if necessary.

After it is redissolved store it in a plastic bag on top of your water heater so it'll stay a little warm and not come out of solution again. It might also be smoother and possibly less painful when you use it. Only keep the couple of vials you are currently pulling from warm though, not your whole stash of course.