what size gauges and length of needle

boricuarage

boricuarage

Banned
i been trying to figure out what sizes of syrgines I should use for injection... I seen from 22-23 as recommended and 1 inch in length... my sites would be shoulders and quads not the ass... can I go for a half inch for shoulders?
Since it will be test e I will shoot twice a week...

comments and bashing are more than welcome ;-)
 
Use a 20 ga to pull and then a 25 ga/ 1inch to shoot in those areas if you are relatively lean. It may take a little longer to go in, but provides for less scar tissue in my opinion down the road.

If you find the Test E too slow, just warm it up a little.
 
rtm said:
Use a 20 ga to pull and then a 25 ga/ 1inch to shoot in those areas if you are relatively lean. It may take a little longer to go in, but provides for less scar tissue in my opinion down the road.

If you find the Test E too slow, just warm it up a little.
Click to expand...

What he said. Glad some people on here know what there talking about.
 
23 ga, 1 inch. I would save my old pin and use it to draw out of the vile. Than put the fresh one on to poke up glute.
 
why would you pull with a smaller gauge and shoot with a larger one? i think you have it back wards. An 18 gauge needle is a lot bigger than say a 25 gauge needle.
 
I am currently running Test E, i draw with a 25g 1'', and shoot with a 27g .5''-im lean. but it is a pain in the ass drawing with a 25g-like said earlier it needs to be warmed up a little. i agree to use a 22-23g 1'' to draw and pin with a 25g, glute/quad prolly 1'', delts and ventraglute could do with a .5''. -if lean. most do use a 1'' for injection. could really use any size you're comfy with-as long as you get it an your meat, but i would not recomend going lower than 27g with enth.
 
my buddy used 20G 1'' to draw and to inject in quads he used 25G 1.5'' this is correct right? it was test-e
 
You must log in or register to reply here.
Back
Top