SD after Oratropin cycle...

  • Thread starter Thread starter ItriedtoripoffBobosonowIamgonehaveaniceday
  • Start date Start date

ItriedtoripoffBobosonowIamgonehaveaniceday

Guest
Hey guys, after my experiment with OT I want to pretty much jump into my Superdrol cycle which I have waited a couple of months for!!!!!!! I am unsure if I should do it solo to gauge its effectiveness or whether to stack it with some MDHT or 1AD as I am attempting to cut and/or recomp! I also have M4OHN and MethylDien on hand. I was also thinking of using T3 at low doses for it's ability to increase protein synthesis or at a higher dose range to just rip up. Let me guys know what you have done, or would like to see done and what seems the most effective for a cutter/recomp (it seems many are putting about 8lbs of weight on while dropping a percent of bodyfat on reduced calorie diets). I wanna start soon so any and ALL info is appreciate......comments are welcome by ALL but DR.D and Sledge are begged to comment on this! Thank you guys!
O, libido may be an issue so please keep that in mind....I would rather go on a libido killer cycle in the winter or summer, just not at this time for personal reasons....but if it seems more effective post it as well!!!!!!!!!
 
Anybody, bump on what they would like to see!
 
Libido is through the roof on SD. I'm running SD with tri-max right now, I have a log in cycle section.
 
So any ideas on what to stack it with guys? I just want to run an effective cutter/recomp as I have seen many guys with logs here lose weight and add LBM. Thanks guys!
 
I would run it solo at first to gauge its effectiveness. Diet is key if you want it to be a cutter, or bulker remember that and all is well.Invalid Link Removed
 
I ran 30 mgs. ED with 50 mgs. of MDHT the first two weeks. Then in my third week, lethargy hit me like a ton of bricks, then I added 400 mgs. of trans 4AD and that cured the lethargy.
 
Would anybody recommend SD with 25-50mcg of T3 for it's nutrient partioning at smaller doses?
 
I would highly recommend SD/MDHT stack for recomp.

You will feel as though you are constructed of steel yet you will lean out remarkably.
 
Thanks for the info OF (seems disresctful to call one of my elders OLD FART! LOL :)
 
what was your doses for your cycle? Also anyone have info on the T3 addition to my SD cycle at low doses
 
If your cutting, dont waste the SD. you will experience the same results with MDHT and/or M4OHN.
 
BOHICA said:
If your cutting, dont waste the SD. you will experience the same results with MDHT and/or M4OHN.
Click to expand...
I agree that using SD for cutting is a bit of waste but, IMHO, the results would be better with than without.

For recomp I don't think any PH could approach Superdrol's effects.

MaNia my doses started at 20mg SD and 50 MDHT.

I hesitate to tell you what my final doses were because I think the board may not like me setting a poor example for the young'uns.
 
Would 10mg daily of superdrol be effective for use in a strict cutting cycle? This wouldn't be using an excessive amount of this rare item, but I imagine it should still be sufficient to hang onto muscle while cutting.
 
oldfart said:
I agree that using SD for cutting is a bit of waste but, IMHO, the results would be better with than without.
For recomp I don't think any PH could approach Superdrol's effects.
MaNia my doses started at 20mg SD and 50 MDHT.
Click to expand...
Which results did u get?
 
max silver said:
Would 10mg daily of superdrol be effective for use in a strict cutting cycle? This wouldn't be using an excessive amount of this rare item, but I imagine it should still be sufficient to hang onto muscle while cutting.
Click to expand...
For me it would. But if you are heavy (lets say 200lbs or more) i think u need 20.
 
for the effects you are wanting SD to do while cutting, I believe m5aa does the same stuff... for a CUTTING cycle, we aren't talking bulking here. you are wanting to preserve msucle mass, increase strenght, and increase vascularity... m5aa does that, and you dont have to waste such a beautful bulking supplement SD on a cutting cycle.
 
Syr said:
Which results did u get?
Click to expand...
If you're asking what results I got from my SD/MDHT cycle than it was about 4-5 lbs of lean mass. Very lean.

I was doing a lean bulk and started at about 10-12% bf and 169 lbs. I ended at 8-10% bf and 175. My bf is measured by a personal trainer (my girlfriend) with calipers. The calipers won't give a reading at a couple of the measurement sites so its tough to gauge my bf this way.

I'm not going to say how long my cycle was (the young-uns again).

I'm still in PCT now and I've lost little to none of the size/strength/recomp gains.

Bohica I honestly still wonder if M5AA could truly give you what SD could in any type of cycle (including cutting). I agree its a bit of a waste for cutting but I honestly believe from experience that it would be more effective than anything for cutting due to its nature. (i.e. you could actually put on some size while cutting)

Having said that I doubt if I will ever cut with it but that's more because I really don't ever get above 10-12% bf anyway and it truly would be a waste for me.
 
You must log in or register to reply here.
Back
Top