Olympus Labs Transform issue

[x_muscle]

I made a recent order from nutraplanet...EP1C, Ostarine, and transform


I have been using transform for two days. From first application i noticed that the gel is very gritty, and when i rub it on my skin, it feels like rubbing a gel that contains sand in it. When the gel dries it leaves crystal like residue on my skin. I think the formastane is not fully dissolved in the carrier gel. I tried shaking the bottle vigorously, and warming it up a bit, but the problem is still there.

I'm just concerned that the active ingredient wont be delivered if its not suspended properly in the carrier. Any suggestion for this! I dont know if this warrant a replacemnt or a refund

 

[T-Bone]

I made a recent order from nutraplanet...EP1C, Ostarine, and transform
I have been using transform for two days. From first application i noticed that the gel is very gritty, and when i rub it on my skin, it feels like rubbing a gel that contains sand in it. When the gel dries it leaves crystal like residue on my skin. I think the formastane is not fully dissolved in the carrier gel. I tried shaking the bottle vigorously, and warming it up a bit, but the problem is still there. I'm just concerned that the active ingredient wont be delivered if its not suspended properly in the carrier. Any suggestion for this! I dont know if this warrant a replacemnt or a refund[

Happens all the time with trans-dermals. Get cup or a mug, fill it about half way up with water. Microwave for 1-2 minutes till its hot. Take the top off of the transform and place the bottle in the hot water. You might have to hold it down if it's not heavy enough, which is usually the case. So just sit there for a few minutes and hold it in the hot water, swirl it around a few times. I'd keep it in at least 5 minutes or until the water cools. By the way, make sure the water is really hot, close to boiling. After you've let it sit for at least 5 minutes put the cap or cover back on and shake the crap out of it. Repeat this process 2 or 3 times and everything should be good.

 

[x_muscle]

I will give it a try and report back

 

[x_muscle]

Okay the solution keep crashing, after i heat and shake. Im contemplating adding more solvent (isopropyl alchol) to see if that might help. This will screw the dosage. i really think Olypus labs should work on their quality control issue. You cant except the customer to do some compounding/mixing/chemistry to use their product. i just feel like im rubbing sand on my skin every time i use this stuff

 

[IFN15]

Simple fix use a little dmso or a few sprays of e-pharm pump spray and it will go through the skin.

 

[DevilDog2136]

That's normal for all form products no matter the carrier. It still works great. Just apply, dry, then apply hand sanitizer over it to assist with absorption. I've used transform and formeron and both products were liked this and both worked very well.

 

[uubiduu]

That's normal for all form products no matter the carrier. It still works great. Just apply, dry, then apply hand sanitizer over it to assist with absorption. I've used transform and formeron and both products were liked this and both worked very well.

I even found transform to be the product easier to apply.