lilmansi
New member
I'll give you a bit of a background and we can go from there.
I have ran a Superdrol clone before, Dymethazine, and had relatively good success. I ran it for a total of 4 weeks, gained roughly 15 pounds, and strength went up considerably. Towards the end of the fourth week I started having sensitive nipples and slight clear discharge when I squeezed them. I was a bit worried at the time, and finished off with 4 weeks of reversitol and two weeks of formestane. At the time I did not have the proper PCT and will admit that now.
Now, a few years later, I occasionally have slight nipple pain and can still manage to get the clear discharge on occasion. I have ran H-drol and Estane since with no further issues.
I am at the point where I would like to run another cycle of M-drol, but I am wondering if that is the best option given my history. I would run an AI while on cycle, adex or or caber, while on and have the proper pct outline this time. However, herein lies the question: Has anyone had similar issues to mine, and then, with the proper precautions taken, run a successful cycle without the outline issues?
I have ran a Superdrol clone before, Dymethazine, and had relatively good success. I ran it for a total of 4 weeks, gained roughly 15 pounds, and strength went up considerably. Towards the end of the fourth week I started having sensitive nipples and slight clear discharge when I squeezed them. I was a bit worried at the time, and finished off with 4 weeks of reversitol and two weeks of formestane. At the time I did not have the proper PCT and will admit that now.
Now, a few years later, I occasionally have slight nipple pain and can still manage to get the clear discharge on occasion. I have ran H-drol and Estane since with no further issues.
I am at the point where I would like to run another cycle of M-drol, but I am wondering if that is the best option given my history. I would run an AI while on cycle, adex or or caber, while on and have the proper pct outline this time. However, herein lies the question: Has anyone had similar issues to mine, and then, with the proper precautions taken, run a successful cycle without the outline issues?