pistonpump
Banned
I just got thru pinning 2cc (1cc stealth test e, 1cc EQ 300mg). So i drew 1 cc of air into syringe swabbed vial of test and injected 1cc of air then pulled 1cc test into syringe.
I then drew another 1cc of air into syringe and proceeded to inject the air into the EQ vial. I then pulled get this, 1.5 cc of eq into the syringe. Im wondering if it was a mistake but i kept the needle facing up and then shot the .5cc back into the eq vial. Pulled out and had 2cc in syringe. Capped needle and took a very warm shower.
Got out of shower dried off good and sat on the bathroom sink counter. I swapped the needle to a 25g 1" and picked a site 1/2 between my knee and butt or hip and pointed it out to make sure it was muscle.
I then swab the needle with alcohol and then the injection site. I insert and it was pretty painless i kept going in until only a fraction of the needle was showing. I was careful to feel for any sharp pain(like hitting a nerve) and i was clear. I aspirated and saw a slight air bubble come into the chamber. All good right? So i proceed to push the plunger down slowly. (Keep in mind i didnt warm the oils). I then started to feel my left foot somewhat getting tingly and numb. I was shooting in right quad btw.
Now im not sure if something went wrong or if it was a combonation of nervousness and the position i was sitting in that i felt this foot almost fall asleep. After pulling the pin out i didnt really feel anything except right when the pin came out. Then i immediately put pressure on the site with alcohol swab.
I hope this is of some use to other injection noobs out there and I was hoping some experienced users could let me know what i did wrong or what i could have done better. THanks.
I then drew another 1cc of air into syringe and proceeded to inject the air into the EQ vial. I then pulled get this, 1.5 cc of eq into the syringe. Im wondering if it was a mistake but i kept the needle facing up and then shot the .5cc back into the eq vial. Pulled out and had 2cc in syringe. Capped needle and took a very warm shower.
Got out of shower dried off good and sat on the bathroom sink counter. I swapped the needle to a 25g 1" and picked a site 1/2 between my knee and butt or hip and pointed it out to make sure it was muscle.
I then swab the needle with alcohol and then the injection site. I insert and it was pretty painless i kept going in until only a fraction of the needle was showing. I was careful to feel for any sharp pain(like hitting a nerve) and i was clear. I aspirated and saw a slight air bubble come into the chamber. All good right? So i proceed to push the plunger down slowly. (Keep in mind i didnt warm the oils). I then started to feel my left foot somewhat getting tingly and numb. I was shooting in right quad btw.
Now im not sure if something went wrong or if it was a combonation of nervousness and the position i was sitting in that i felt this foot almost fall asleep. After pulling the pin out i didnt really feel anything except right when the pin came out. Then i immediately put pressure on the site with alcohol swab.
I hope this is of some use to other injection noobs out there and I was hoping some experienced users could let me know what i did wrong or what i could have done better. THanks.
