formestane in penetrate

paint2100

Member
I have an 8 oz bottle of penetrate and 5 grams of formestane and it wont fully absorb. I have done the hot bath method and shaken it like crazy. Any advice would be appreciated
 
Put a small ball-bearing inside the bottle. It helps to break up the fragments of powder.
 
Dido, or if you want you could throw the mix into a glass beaker or jar and superheat it to get the stuff to dissolve. This worked good for me when I added 10gr of triol to penatrate.
 
Agreed...you should easily be able to get 5 grams into 8 ounces.
 
I'm going to run the same thing, I just purchased both of these products from NP. The only question I have is what would be the proper dose when using transdermally?
 
I found the best results (assuming 10 grams in 8 ounces of Penetrate) at 4 squirts twice per day.
 
I couldnt get 10 grams to absorb into 8 oz of penetrate. I heated it up in a glass container and I think I got partial absorption, put there is still lots of powder left behind when I apply this stuff. I'm going to try and heat it again at a higher heat and see if I can get this to absorb. Hopefully it works out this time, quite the pricey science experiment. I assume exteme heat will not harm the form?
 
z28man said:
I couldnt get 10 grams to absorb into 8 oz of penetrate. I heated it up in a glass container and I think I got partial absorption, put there is still lots of powder left behind when I apply this stuff. I'm going to try and heat it again at a higher heat and see if I can get this to absorb. Hopefully it works out this time, quite the pricey science experiment. I assume exteme heat will not harm the form?
Click to expand...

It depends on what you mean by extreme heat.

Break up whatever is sitting at the bottom with a small rod, heat up in hot water, and if all else fails, add more carrier or solvent.
 
You must log in or register to reply here.
Back
Top