Drawing Sustanon with 25 g

triton185

triton185

Member
I am just starting my first cycle. Sustanon 250. I was trying to draw with a 25g needle.....cannot get it to draw. Anyone have this problem and do I also need to go bigger with the injection pin. Sorry....first time.
 
always draw with a 22 gauge or higher, i use 20. u MIGHT be able to pin with a 25, but it will take some time to inject
 
I've heard that the 22g pins are pretty versatile...
 
OK. thanks. think i might pin with something else. the little bit that did draw came out very slowly. thanks again.
 
I've seen people suggest injecting some air into the vial too...not sure if this should be done or not though...any takers with details for this suggestion?

I'm guessing it would be in direct proportion to the volume that is being drawn, no?
 
stxnas said:
I've seen people suggest injecting some air into the vial too...not sure if this should be done or not though...any takers with details for this suggestion?
Click to expand...

Drawing a full syringe of air, and then shooting that into the vial is a good way to help...It creates pressure inside the vial, and otherwise once you start drawing out there is actually a vacuum inside the vial. Still, though, a 22 guage is relatively small to be drawing a thicker oil with.....

holy
 
holyintellect said:
Drawing a full syringe of air, and then shooting that into the vial is a good way to help...It creates pressure inside the vial, and otherwise once you start drawing out there is actually a vacuum inside the vial. Still, though, a 22 guage is relatively small to be drawing a thicker oil with.....

holy
Click to expand...


dead on...i always shoot a full syringe of air first...makes it much easier...
 
You must log in or register to reply here.
Back
Top