crystal in vial of test

doot11

New member
Has anyone ever had a vial of test show up with a crystal looking thing in it? My supplier had always sent good stuff. I have the vial in hot water now to see if it dissolves. Thanks
 
doot11 said:
Has anyone ever had a vial of test show up with a crystal looking thing in it? My supplier had always sent good stuff. I have the vial in hot water now to see if it dissolves. Thanks
Click to expand...

Yes have had this before was test prop. I put the vial on a pan and in the oven on low setting or 200°f and kept watch on it shaking it up every five min or so until dissolved.
 
Its from a domestic ug source ive used for awhile. Great service just never seen anything like it. What do you mean by crashed? Thanks for the feedback
 
Crashed as it was suspended and fell out of suspension.
 
Got it. Im heating up the test prop by putting the vial into a cup of hot water. I take it out every few min and shake. Any other ideasb on reintegrating?
 
Try heating it to 118°c or 244°f. Assuming it's prop. Might be able to get away with a lower heat.
 
The problem is with no venting you might crack the vial with higher temps.. you should really vent while heating then filter adding more BA & BB to get it to hold
 
pro520roost said:
Yes have had this before was test prop. I put the vial on a pan and in the oven on low setting or 200°f and kept watch on it shaking it up every five min or so until dissolved.
Click to expand...

Do this. Vent the cap with a 22ga pin.
 
You must log in or register to reply here.
Back
Top