Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

BDC "new and improved" t-gel

morfiend

Member
I've been using this for like 2 weeks now, but I've noticed that the pumps seem to be pretty inconsistent. Sometimes they're small othertimes a shitload (looks more than 2 ml?) comes out.. if it comes out lookin short I'll usually give it another half-pump, but this isnt' that accurate.

Anyone else have this problem, what'd you do to make sure you always get the correct dose?
 
morfiend said:
I've been using this for like 2 weeks now, but I've noticed that the pumps seem to be pretty inconsistent. Sometimes they're small othertimes a shitload (looks more than 2 ml?) comes out.. if it comes out lookin short I'll usually give it another half-pump, but this isnt' that accurate.

Anyone else have this problem, what'd you do to make sure you always get the correct dose?
Click to expand...
How much **** you shove in the bottle? is it mixed well? only thing i can think of.
 
7.5 g of 4-ad and 2.5 mg 1test ... i've heated it in near boiling water 3x so far, and i'll shake it like crazy before every application. after using it when it was in the water did help a lot you're right, just a pain to have to do that everytime. thx
 
I went to the local drug store and bought an oral syringe. It works a lot better than guessing with the pumps.
 
Saggy said:
I went to the local drug store and bought an oral syringe. It works a lot better than guessing with the pumps.
Click to expand...


**** trans... its all about pinning!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!


tran'ing is for pussies.
 
rhatid said:
**** trans... its all about pinning!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!


tran'ing is for pussies.
Click to expand...

Hell yeah, I just recently stepped into the darkside and I'm loving it.
 
rhatid said:
**** trans... its all about pinning!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!


tran'ing is for pussies.
Click to expand...
If you post more of this type of bullshit, don't bother posting at all.


Stop encouraging the meathead mentality Einstein.
 
Bobo said:
If you post more of this type of bullshit, don't bother posting at all.
Stop encouraging the meathead mentality Einstein.
Click to expand...


To add to this, it appears that one of the AAS products being distributed by BALCO was in the form of a transdermal. You can't argue with the results from those athletes.
 
I use a measuring spoon set, and measure my dosages. It pours right into the spoon for easy accurate dosing.

Here are the conversions.

1/8 tsp = 0.6 ml
1/4 tsp. =1.2 ml
1/2 tsp = 2.4 ml
1 tsp. = 4.8 ml
 
Heating in hot water before each application should not be necessary. It may be that the dose reservoir is taking air as it thins and shaken (the reservoir is below the pump head on the bottom, should have a small hole on the side to allow for pressure equalization).

Help me visualize the problem: Does the first pump or two dispense air before the lotion starts coming out or does it deliver some lotion and spurt some air? In this case the pump head must be primed because air in the reservior. I have tested the pump heads many times using different viscosity liquids and the accuracy has been measured. The only time I had consistent difference is when shaken REALLY HARD and then only the first few dispenses were affected.

If I'm on the money with my description of the problem then to prime the pump head you need to do the following: push the pump head up and down a few times BUT DO NOT GO ALL THE WAY DOWN. In my experience, it only takes about 1/16-1/8" travel downward and maybe 4 or 5 times. You'll know it is primed when that small of a movement downward results in a tiny bit of lotion coming from the pump head.

Tell me how it goes...

Chemo
 
By george i think hes got it... it did the same thing to me, but I reckon the transdermals are a little more lenient than methyls. I got it at a nice consistent rate after a couple weeks.
 
most drug stores sell an oral syringe combined with a rubber stopper that has a capped hole in the top. I have been using mine for the past several months with the BDC gel and it works great. I just remove the pump and put the rubber stopper in the bottle. Then when I need to use it, I shake the bottle, take the top of the rubber stopper and place the syringe inside the hole. Turn it upside down and draw out exactly the ml you want. I tried just using the syringe in the bottle, but the chemicals quickly dissolved the graduated measurements on the side of the syringe.

I have attached a photo of the product being sold by walgreens (and available at their website).
 
If you can, get one with a narrower body as it makes it easier to draw out small amounts. A syringe will work as well.
 
Chemo said:
If I'm on the money with my description of the problem then to prime the pump head you need to do the following: push the pump head up and down a few times BUT DO NOT GO ALL THE WAY DOWN. In my experience, it only takes about 1/16-1/8" travel downward and maybe 4 or 5 times. You'll know it is primed when that small of a movement downward results in a tiny bit of lotion coming from the pump head.

Tell me how it goes...

Chemo
Click to expand...


thanks chemo your method works like a charm... :D
 
You must log in or register to reply here.
Back
Top