Smolder consistency question

[ironfiend23]

I boughty Eviscerate Smolder to alternate with Androlo for a 2-4 week cut . Been on Brite, Epitome and DCP for 8 weeks with Lean Edge and Mitoburn.

Should the consistency be liquid? I put it on 10 hours ago and every time I start to remotely sweat its unbearably hot/borderline painful. I don't mind heat...actually like a little but this is well more than expected. Wondering if it should be a more gel like consistency? I don't think I can use this regularly if this is typical .Thanks

 

[dsade]

Should be a thinner gel-like consistency. If it gets warm it can thin out as well.

If you want to to thicken it, unscrew the pump and add a tiny but of warm water then shake.

 

[ironfiend23]

Should be a thinner gel-like consistency. If it gets warm it can thin out as well.

If you want to to thicken it, unscrew the pump and add a tiny but of warm water then shake.

@dsade Thank you! Is this level of burn consistent with smolder? Any suggestions to calm it down? Cold shower and loofa? Was looking to run this with the aforementioned Evomuse supps and high dosing the DCP. Bummer if I can't.

 

[dsade]

The burn level is medium. You can try using less and spreading over wider area.