Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

PCT Noob Questions

jab10231

New member
So, bought my first ever SERM (liquid Clomid) for a cycle that was going to begin next month. I got a medicine dropper but in some "practice" runs (not actually administering the Clomid) I have found it VERY difficult to extract exact amounts. Also the Clomid is thick and has a honey/glue-like quality. And the dropper may be too wide for my particular bottle. I would feel a lot safer with another way of doing this. This was going to be my first experience with a SERM, but UI'm apprehensive and will not run the cycle if I can't get the pct worked out.

Any ideas? (Yes I know it's a dumb question, but I'm just trying to do this the right way)
 
Buy a syringe & empty gell capsules, pull the dose into syringe & squirt into capsule & swallow with water. Microwave the clomid for 5 secs to liquify it. Don't exceed 5 secs & dw it doesn't ruin it. Repeat if necessary.
 
Last edited:
Glass is fine & only doing so for 5 sec intervals. Syringe will deff help with dosing which you can squirt straight down your throat if you don't mind the taste lol
 
As did I.
Worked fine in my last pct. I guess I didn't know that it's texture changes company to company.
 
The dosage just isnt coming out at all. The consistency seems weird. I plop it down in the depressed all the way and try to suck it up into the syringe, I got it up to about .8 ml and couldn't get any more. I can't tell if this is just a bad bottle or what. This was from a company recommended here. I feel like I'd be so much better off with caps.

Admittedly I've like never ever used syringes before, but this seems like a very big chore.
 
So it's coagulated? You need heat it a little to kinda liquify again. Put warm water in a bowl & sit the bottle of clomid in it until the viscosity can be better administered.
 
Chevy said:
So it's coagulated? You need heat it a little to kinda liquify again. Put warm water in a bowl & sit the bottle of clomid in it until the viscosity can be better administered.
Click to expand...

You sir, win at life. I heated some hot water up in a coffee cup for a minute and 15 and let the bottle sit in there for five or six minutes. It came right out after that. Thanks so much, this rocks! I'm so excited to get theis cycle started I wish I could start tomorrow.
 
one trick i've learned...they sell these little rubber adaptors at the common drug store (for things like liquid tylenol). its a little cone shaped piece of rubber that you push into the mouth of the bottle and it has a hole that runs through the center. use this if your oral syrenges are too big. you put the syrenge in the hole, turn the bottle upside down and draw the amount you need into the syrenge. and you can reuse the adaptor as long as you like
 
You must log in or register to reply here.
Back
Top