RPM and Drive

noot

Member
Are there any special dosing instructions if taking RPM and Drive together? Or following their individual directions be fine?
 
No hard and fast rules, just work out what feels right to you.

I did well on 1 RPM and 2 Drive pre-WO, but everyone is diff'ernt.
 
Are there any special dosing instructions if taking RPM and Drive together? Or following their individual directions be fine?

Just follow the dosing/timing instructions on the label.

RPM
Resistance Training Days
Dose* - 60-80 minutes pre-resistance training (I would start with the lower end of the recommended dose to assess tolerance, and then go to the higher end of the dosage if ok)
Non-Resistance Training Days
Dose* - once daily (most often dosed first thing in the morning, but whenever you like, really; and this is OPTIONAL).

Drive
Resistance Training Days
Dose 1* - first thing in the morning
Dose 2* - 60-80 minutes pre-resistance training (i.e. with RPM dose)
Non-Resistance Training Days
Dose 1* - first thing in the morning
Dose 2* - 6-8 hours after Dose 1

* Dosage is weight dependent - see the chart on the label.


~Rosie
Team APPNUT
 
I was wondering, can I continue taking Jack3d if I start taking RPM+Drive? Or should I take one or the other and not together?
 
I was wondering, can I continue taking Jack3d if I start taking RPM+Drive? Or should I take one or the other and not together?

Depending on your tolerance to stims, I would recommend either using Jack3d or RPM. But if you're ok, then both can be used together.

~Rosie
Team APPNUT
 
Back
Top