white clumps in carrier

k man

New member
mixed up 15g of test base in 240ml of penertrate but i can see white clumps which float to bottom of jar

how can i get it desolved proper ?
 
k man said:
mixed up 15g of test base in 240ml of penertrate but i can see white clumps which float to bottom of jar

how can i get it desolved proper ?
Click to expand...

Did you heat it? Have you tried putting a marble in it?
 
bpmartyr said:
Did you heat it? Have you tried putting a marble in it?
Click to expand...

tried placing the bottles in hot water for a while no joy thou

not tried a marble yet

could i use a metal bolt ?
 
Sounds like you dumped all the powder in at once. Hmmm... maybe a hand mixer? A search before jumping in would have proven helpful here.

Invalid Link Removed

dd
 
diamonddave said:
Sounds like you dumped all the powder in at once. Hmmm... maybe a hand mixer? A search before jumping in would have proven helpful here.

Invalid Link Removed

dd
Click to expand...

ok so i should of searched that but i tried couldnt find anything like what was said in that thread but i know now

anyways i added 5 g at a time then shaked inbetween

the EQ is nearly fully desolved but the test isnt

what would you recommend i should do to desolve it

could i try the microwave 10 to 12 secs ?
 
ok so when ppl say heat it up is that with the hormone in solution or just the solution on its own?
 
It's too late to warm it up without the powder right? Just don't overheat it, it may damage the compound. Put a pan of water on the stove, heat it until litle bubbles begin to form on the bottom of the pan, but don't let it get to a full boil, remove the pan from the burner, then put your bottle of carrier in the water for about 10 minutes. Then try the marble/ball-bearing trick, or the hand mixer. Do you have one of those long, single high-speed bladed, hand mixers? I think that would do it.

dd
 
diamonddave said:
It's too late to warm it up without the powder right? Just don't overheat it, it may damage the compound. Put a pan of water on the stove, heat it until litle bubbles begin to form on the bottom of the pan, but don't let it get to a full boil, remove the pan from the burner, then put your bottle of carrier in the water for about 10 minutes. Then try the marble/ball-bearing trick, or the hand mixer. Do you have one of those long, single high-speed bladed, hand mixers? I think that would do it.

dd
Click to expand...

thanks for the advice bro i will give that a go , good job i have plenty of powder LOL
 
You must log in or register to reply here.
Back
Top