Guest viewing is limited

what do you mix your superdrol powder with?

Status
Not open for further replies.
I heard from numerous people that OO will work great with this stuff. 99 ml's will make a nice 10 mg/ml suspension.
 
T-Bone said:
I think you mean 100ml to 1 gram of powder. Otherwise your math would be a bit off.
Click to expand...
No...

These are the best instructions I have found yet.... follow these for proper conversion.

Invalid Link Removed
 
JonesersRX7 said:
No...

These are the best instructions I have found yet.... follow these for proper conversion.

Invalid Link Removed
Click to expand...
Thank you! I have been looking for this particular post all morning!
 
T-Bone said:
I think you mean 100ml to 1 gram of powder. Otherwise your math would be a bit off.
Click to expand...
A good round number for the average weight / volume is 1gram per mL. Therefore, you can assume that 1 gram of SD is roughly 1mL in volume (which is probably incorrect, but at that small of a dose, it doesn't matter much...). Therefore 1mL of SD + 99 mL of Olive Oil = 100mL TOTAL SOLUTION. In the solution, there are 1000mg of SD (1g). Therefore 1000mg/100mL = 10mg/mL.

If you had 100mL olive oil and 1 gram of SD you would get ~101mL of solution, bringing the dose "under" 10mg/mL...It would be about 9.9mg/mL. Either way it's close, but the numbers are correct the other way.

Easiest way to go is to get a 100mL graduated cylinder...add a few mL of Olive Oil...shake it up a litte bit, and then add more olive oil until you are exactly at 100mL. From there, you can conclude that you've got VERY, VERY, VERY close to exactly 10mg/mL.

Hope that clears things up.

K
 
kwyckemynd00 said:
A good round number for the average weight / volume is 1gram per mL. Therefore, you can assume that 1 gram of SD is roughly 1mL in volume (which is probably incorrect, but at that small of a dose, it doesn't matter much...). Therefore 1mL of SD + 99 mL of Olive Oil = 100mL TOTAL SOLUTION. In the solution, there are 1000mg of SD (1g). Therefore 1000mg/100mL = 10mg/mL.

If you had 100mL olive oil and 1 gram of SD you would get ~101mL of solution, bringing the dose "under" 10mg/mL...It would be about 9.9mg/mL. Either way it's close, but the numbers are correct the other way.

Easiest way to go is to get a 100mL graduated cylinder...add a few mL of Olive Oil...shake it up a litte bit, and then add more olive oil until you are exactly at 100mL. From there, you can conclude that you've got VERY, VERY, VERY close to exactly 10mg/mL.

Hope that clears things up.

K
Click to expand...
Ok then would this work?. I have an old bottle thats 240 ml with a 5ml oral syringe I can use. I just measure out the Peg 400 or the EVOO as 100ml in a measuring cup. Then I draw out 1 ml with my syringe. Then I put the powder in my old container then pour the olive oil in. Keep the cap off and heat for around 15 seconds in the mirowave, put the cap on and shake?. By the way are you guys sure it will disovle in olive oil or should I get the PEG 400 to be safe?. Understand I just don't want to waste it, but want to make this simple and painless for my meager brain. Can I just add 2 grams to the olive oil and mix it in and just leave it for a few months or will it spoil. I know it was mentioned the Olive oil has a lot of antioxidant properties so it would keep longer. I won't be able to use it for a while though.
 
Microwave?... bump after 2 hours durring dinner time.....!

Jonesie Slaps T-Bone with a wet trout....

:trout:

Um... I'm no chemist or anything... but my sense tells me that I would rather boil a pot of water and then place container in there to heat... who knows how the microwave could change the chemical structure. Also... why the need to do this right away? If not going to be used for a while I think it would be better to keep seperate until ready to use.

Spend some money on good glass wear. I'm in the process of looking for some now.. i'll post up if I find a good site.
 
JonesersRX7 said:
Microwave?... bump after 2 hours durring dinner time.....!

Jonesie Slaps T-Bone with a wet trout....

:trout:

Um... I'm no chemist or anything... but my sense tells me that I would rather boil a pot of water and then place container in there to heat... who knows how the microwave could change the chemical structure.

Spend some money on good glass wear. I'm in the process of looking for some now.. i'll post up if I find a good site.
Click to expand...

Microwaving was suggested by the owner of the site that sold me the powder!. He suggested puting it in the micro for around 15 seconds.
 
T-Bone said:
Ok then would this work?. I have an old bottle thats 240 ml with a 5ml oral syringe I can use. I just measure out the Peg 400 or the EVOO as 100ml in a measuring cup. Then I draw out 1 ml with my syringe.
Click to expand...
Good, so by here you have 99mL of solvent.
Then I put the powder in my old container then pour the olive oil in.
Click to expand...
Personally, I would add some of the OO or PEG first so taht the powder doesn't stick to the sides of the container.
Keep the cap off and heat for around 15 seconds in the mirowave, put the cap on and shake?.
Click to expand...
As was mentioned earlier, the microwave may not be a good idea. Just heat the water up (you can heat the water in the micro ;)) and then let the bottle sit in the warm water.
By the way are you guys sure it will disovle in olive oil or should I get the PEG 400 to be safe?.
Click to expand...
I hear OO works fine, but I don't know. I haven't received my powder yet ;)
Understand I just don't want to waste it, but want to make this simple and painless for my meager brain. Can I just add 2 grams to the olive oil and mix it in and just leave it for a few months or will it spoil. I know it was mentioned the Olive oil has a lot of antioxidant properties so it would keep longer. I won't be able to use it for a while though.
Click to expand...
It shouldn't spoil. But, if you add 2grams, I'd recommend using 198mL of PEG or OO b/c I read elsewhere that @ 20mg/mL (100mL solvent + 2grams of SD) didn't fully suspend the the SDrol.

So:

Step 1: Measure out 99mL of solvent per gram of SD powder.
Step 2: Add a portion of the solvent into the target container.
Step 3: Add the SD powder (1g:99mL for 10mg/mL)
Step 4: Add the rest of the solvent.
Step 5: Shake like hell. (edit: Or don't shake like hell????)
Step 6: If the solution appears to be holding (I'd recommend a clear container) then there probably is no need to heat it and you are done. Otherwise, put it in a hot/warm water bath and shake occassionally until it is fully dispersed and in solution. You can always give a hot water bath just for fun, too ;)

*You shouldn't need HOT water. Warm should be fine. You want to put it in a container that the SDrol solution cannot fall over into, and you want to have the water level low enough that when you add the SDrol solution's container into the water bath, that water does not engulf and potentially enter the container of SDrol solution.

That should work. I've not made a solution yet, but if 10mg/mL solutions in OO are holding, then the above process should work fine.

K
 
Oh, and re: OO v. PEG:

DR.D said:
I agree, PEG makes me wanna puke. Even if the powder doesn't totally dissolve in oil, it will be quite accurate if you just invert it 5 or 10x (you don't have to shake it hard) before each use. You can buy PEG anywhere, LaMage (sp?), DS, any research kit site, etc.. But I recommend oil, even though PEG in not toxic, just because of the taste.
Click to expand...
From another thread...
 
kwyckemynd00 said:
Good, so by here you have 99mL of solvent.
Personally, I would add some of the OO or PEG first so taht the powder doesn't stick to the sides of the container.
As was mentioned earlier, the microwave may not be a good idea. Just heat the water up (you can heat the water in the micro ;)) and then let the bottle sit in the warm water.
I hear OO works fine, but I don't know. I haven't received my powder yet ;)
It shouldn't spoil. But, if you add 2grams, I'd recommend using 198mL of PEG or OO b/c I read elsewhere that @ 20mg/mL (100mL solvent + 2grams of SD) didn't fully suspend the the SDrol.

So:

Step 1: Measure out 99mL of solvent per gram of SD powder.
Step 2: Add a portion of the solvent into the target container.
Step 3: Add the SD powder (1g:99mL for 10mg/mL)
Step 4: Add the rest of the solvent.
Step 5: Shake like hell. (edit: Or don't shake like hell????)
Step 6: If the solution appears to be holding (I'd recommend a clear container) then there probably is no need to heat it and you are done. Otherwise, put it in a hot/warm water bath and shake occassionally until it is fully dispersed and in solution. You can always give a hot water bath just for fun, too ;)

*You shouldn't need HOT water. Warm should be fine. You want to put it in a container that the SDrol solution cannot fall over into, and you want to have the water level low enough that when you add the SDrol solution's container into the water bath, that water does not engulf and potentially enter the container of SDrol solution.

That should work. I've not made a solution yet, but if 10mg/mL solutions in OO are holding, then the above process should work fine.

K
Click to expand...

Let me know how yours works out when you get your powder...
 
OO works and I dont see a need to heat it at all. Just shake like hell before you draw any out. Even if you do heat it it will prob come out of solution and into a suspension anyway. I have heard that baby food jars work nicely for these things.
 
T-Bone said:
Let me know how yours works out when you get your powder...
Click to expand...
Will do, but I"m not planning on taking it for a while...therefore, I'm not gonna suspend it for a while. stores better in powder form...
 
kwyckemynd00 said:
A good round number for the average weight / volume is 1gram per mL. Therefore, you can assume that 1 gram of SD is roughly 1mL in volume (which is probably incorrect, but at that small of a dose, it doesn't matter much...). Therefore 1mL of SD + 99 mL of Olive Oil = 100mL TOTAL SOLUTION. In the solution, there are 1000mg of SD (1g). Therefore 1000mg/100mL = 10mg/mL.

If you had 100mL olive oil and 1 gram of SD you would get ~101mL of solution, bringing the dose "under" 10mg/mL...It would be about 9.9mg/mL. Either way it's close, but the numbers are correct the other way.

Easiest way to go is to get a 100mL graduated cylinder...add a few mL of Olive Oil...shake it up a litte bit, and then add more olive oil until you are exactly at 100mL. From there, you can conclude that you've got VERY, VERY, VERY close to exactly 10mg/mL.

Hope that clears things up.

K
Click to expand...
Geez talk about going into detail lol. A simple "Just use 99ml gah damnit" would have sufficed ;)
 
Status
Not open for further replies.
Back
Top