Tren solution question

jblaze22

Board Supporter
so i ordered some tren to make my pet iguana look like GOOOOZILLLA


problem is, it doesn't look like its dissolved very well, is this normal?


its enanthate btw. Thanks
 
what BA/BB/Oil/Powder ratio...what mg/ml....and did you ever heat for a short while to try and put it into solution?
 
Add 4% BB and 1% BA, then heat in the oven at 250 for a few minutes, or on a hot plate. Make sure you vent it while doing so.
 
Unfortunately all i know is its a 20ml vial @ 200mg/ml

The supplier is supposedly reputable so i trust its just a fluke, but ill try adding some alcohol and heat and see what happens

I should note its not all that bad, just some extra undissolved something or other at the top and bottom if i let it settle, ill let you all know

thanks.

kwyckemynd00 said:
what BA/BB/Oil/Powder ratio...what mg/ml....and did you ever heat for a short while to try and put it into solution?
Click to expand...
 
Ubiquitous said:
Add 4% BB and 1% BA, then heat in the oven at 250 for a few minutes, or on a hot plate. Make sure you vent it while doing so.
Click to expand...

thanks much, will try that.
 
sometimes oxidized fina will colect on the bottom of the vial. is it a redish? the sedement I mean., if its just a little on the bottom and redish (looks almost like something seperarted) ether dont' worry about it or refitler it. if its more or if reheating doesn't do it then I would def refilter.

then again I have seen tren e that still had tren base in it. that would be much harder to desolve.
 
i actually just heated it up all ghetto last night in front of my electric heater and this morning lo and behold it was perfectly clear, so hopefully it doesn't crash again.

All i can figure is maybe it was cause of the temperatures during shipping? either way it seems to be all set now, but thanks again to all
 
You must log in or register to reply here.
Back
Top