testosterone suspension in oil.

chemist

New member
how are you all?

Well I am trying to make testosterone suspension soluble in water or oil. what are the procedures and the half life of the product. I want to make it at 10mg/ml.

thanks
 
test suspension is hard say the least.

if you want to suspend in water a couple things you should know.
1) you need MR.T's kits
2) water is more exceptable to bacteria infections.

in oil its hard to get a homogenous product but it can be done..I will post all my experiments with this
 
diablo69 said:
test suspension is hard say the least.

if you want to suspend in water a couple things you should know.
1) you need MR.T's kits
2) water is more exceptable to bacteria infections.

in oil its hard to get a homogenous product but it can be done..I will post all my experiments with this
Click to expand...

1) Nobodies kits are needed, he can do it on his own
2) Bacteriostatic water will do the trick


Why do you want only 10mg/ml? Or is this a typo?
 
ex_banana-eater said:


1) Nobodies kits are needed, he can do it on his own
2) Bacteriostatic water will do the trick


Why do you want only 10mg/ml? Or is this a typo?
Click to expand...

Break it down then for us so, we can learn.
I have been on alot of board concerning conversions. Maybe I have been miss guided.
 
Being that you can obviously not 'syringe filter sterilize' a suspension, how is the powder itself sterilized before you put it in the bacteriostatic water?
 
Suspension

Isn't is possable to put some alcohol into the vial. Mix it around till it touches 100% of the interior. Then put in the powder hormone and sterile water (0.9% Benzyl Alcohol). Put on a cap and there you go.

The remaining Alcohol should kill all the bacteria and viruses in there.

Hell, why doesn't everyone just get a Ultra Violet Light and sit it under it for a day or so? UV kills everything, they do that to clean drinking water...

Does UV light degrade the Hormone?...
 
Re: Suspension

gorillaproject said:
Isn't is possable to put some alcohol into the vial. Mix it around till it touches 100% of the interior. Then put in the powder hormone and sterile water (0.9% Benzyl Alcohol). Put on a cap and there you go.

The remaining Alcohol should kill all the bacteria and viruses in there.

Hell, why doesn't everyone just get a Ultra Violet Light and sit it under it for a day or so? UV kills everything, they do that to clean drinking water...

Does UV light degrade the Hormone?...
Click to expand...

Nada, the impurities in the powder needs to be filtered out along with the bacteria that is in the powder. The powder itself is not sterile and ba will not do anything further to sterilize it if there are impurities.
 
I was just thinking, what if you were to dissolve the test base in 99% isopropyl alcohol, which should kill all bacteria, then bake the alcohol off at relatively low temperature, then add bacteriostatic water.... would that not do the job?
 
You must log in or register to reply here.
Back
Top