Test Enan White Slush?

CaseyW

CaseyW

New member
When transferring from a pack to a vial the needle is getting stopped up.. after opening the pack I see there is constantly these bunches of what looks like semi solid white slush getting caught in the needle tip and stopping it up?

Is this normal? Never encountered this before?
 
Most likly your oil has crashed... Hit up the supplyer and tell him your problem. Should resend no questions asked
 
This can work but it will just end up fallin out again... You don't want it to fall after it's been injected, not fun! Shot crashed oil 1x and will never do it again.
 
usealittle said:
This can work but it will just end up fallin out again... You don't want it to fall after it's been injected, not fun! Shot crashed oil 1x and will never do it again.
Click to expand...

well.... ****.... Ok, I had no idea such a problem existed... I took 1.25ml of the stuff... what do I have to look forward to???
 
Some times as long as it don't crash harder once you've injected it then you should be able to get away with nothing, but the worst I would say is injecion site pain till the body absorbs it.
 
usealittle said:
This can work but it will just end up fallin out again... You don't want it to fall after it's been injected, not fun! Shot crashed oil 1x and will never do it again.
Click to expand...

Sometimes heating it up will solve the problem and sometimes you have to do it everytime you inject. As long as the solution is completetly liquid when injected it should be ok.
 
Sounds like crystallization from over saturated gear. Most guys warm it up and the crystals go away.
 
I've also heard of guys storing their gear below room temp. Bad idea. It will definitely crystallize below room temp.
 
You must log in or register to reply here.
Back
Top