Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

Test E only cycle

bjw181

New member
I have been a long time reader of these forums and just recently decided it was time to make an account and ask some questions because, well, I need answers! I am not one to jump head first into things. I research the hell out of any big choice and make in life and this is one of those choices. But first, some background info is in order...

Age 26
Height 6'3"
Weight 190 lbs
BF ~ 16-18%

I have been an athlete since HS. I played varsity football since I was a freshman and have been working out since I was 14. However, I wasn't really completely serious until I got to college where I was hitting the gym regularly. However, my diet wasn't in order. While I did get much stronger since my HS days, I wasn't much to look at. I had done what is I hear a "dirty bulk" consisting of cheap cafeteria food, beer, and protein shakes. I was about 225 lbs. and about 20% BF or more...but I could bench 290 lbs and squat close to 425 lbs so I didn't really care, even if my heart and cardio health said differently.

After college I kept working out and got myself to a more acceptable body composition with diet and HIIT, but my lifts seemed to always stall at the same points. I may push my diet overboard for a couple months and add a few more lbs. to my squat at the expense of BF, but I always seem to revert back to my old numbers.

So I spoke with a friend who cycles. He hooked me up with a first cycle for me, but I have a few questions about:
1) The products
2) The process

So this is my inventory:

Test E 400mg/ml
Liquid Exemestane (Aromasin)
Liquid Clomid
10 pins with 10 smaller gauge needles

My plan:

Weeks 1-10: 400mg/wk
Weeks 1-3: 15 mg Aroma ed
Weeks 3-8: 25 mg Aroma ed
Weeks 8-13: 10 mg Aroma ed
Weeks 10-13: 50 mg clomid ed

And these are my questions:

1) I've read that Test E at 400 mg/ml is quite a bit. I've heard some stories of incredible pain, and others saying it was smooth as can be. I've talked to my friend who assures me that he used the same stuff and it was just fine. It seems to be legit, no crystals and fully suspended. What is your take?

2) The liquid Exemestane (Aromasin). The bottle itself says "600mg, 60mL" word for word. Am I to assume this means 10mg/1mL? If so, why not just write that on the fricking label? Also, it looks like Pepto Bismol.

3) The liquid Clomid. The label is torn slightly from my friend but I think it reads 35mg/mL but then again it could read 85mg/mL. Is 85mg/mL a common ration for liquid Clomid?

4) Side effects. I'm assuming the AI will take care of bloating and what not, but should I be concerned about gyno? If so, what steps should I take to combat it? I've always been somewhat skinny-fat, but not too terribly so. I'm guessing I would be prone to it, hence the heavy AI dosages.

5) My plan. Your take on it?

6) Diet and training. I've always been a strong guy for my size. I always had a pretty high "lbs lifted/lb body weight ratio", and my training never really ventures too far from a power lifting plan. Lots of compound movements and explosive cleans, etc. Diet as of now is iffy. But keep in mind I won't be starting my first injection for about a month while I clean up some weak areas such as a consistent intake of sufficient macros (I tend to under eat when I'm busy). However, this one really isn't a question. There's loads of info out there on this I can search for myself. It's more info for you guys to make a suggestion with for my plan.

So that's it. I apologize for the long post. Any help you guys can offer would be greatly appreciated!
 
Test-e at 400mg/ml is *quite* painful for 90% of the individuals that I've heard about using it. Consider diluting to 200mg/ml, re-sterilizing, and injectnig 2-3 times a week instead, you'll be glad you did IMHO. I've never seen liquid clomid in those doses, its *usually* about 100mg/ml. I have no experience with Aromasin.

ManBeast
 
K so I'm guessing it must be 85mg/mL. The label tore off the bottom part of the first number but it could only be an 8 or a 3. Could anyone share how I would go about diluting and re-sterilizing my solution?
 
You should get some more needles and pin twice a week so yur not blasting 400mg into yur muscle and to keep your blood levels more stable.. I wouldnt bother diluting it. Just split the doses..As far as the clomid i thin it depends on the lab or if its a research chem.. I got a bottle of clomid at home which is 50mg/ml and its a researc chem.a lot of guy will tell tell yu to run aromasi on cycle but i wud say jus have on hand for IF you have symptoms of gyno... You hould also consider lengthening your cycle beacuse the test e is a long ester and wont kick in until around week four so if yu did a ten week cycle it would really only be a 6 week cycle
 
machorox123 said:
You should get some more needles and pin twice a week so yur not blasting 400mg into yur muscle and to keep your blood levels more stable.. I wouldnt bother diluting it. Just split the doses..As far as the clomid i thin it depends on the lab or if its a research chem.. I got a bottle of clomid at home which is 50mg/ml and its a researc chem.a lot of guy will tell tell yu to run aromasi on cycle but i wud say jus have on hand for IF you have symptoms of gyno... You hould also consider lengthening your cycle beacuse the test e is a long ester and wont kick in until around week four so if yu did a ten week cycle it would really only be a 6 week cycle
Click to expand...

Yea this is true. However it is my first cycle and I more or less just want to see how my body will react to it (any symptoms, mass gained, strength/body weight ratio...). My only issue is the AI. I don't know how to dose it. It came in this spray pump bottle so I'm at a loss as to how to dose it.
 
Solve that 4 week test delay with an oral to jump start, you wont regret it. So many available these days, and the current prohormones available are pretty strong as well.
 
T-400 is painful!
Exe-not needed
Clomid is PCT
This cycle will not yield great results, especially for a beginner. Sorry.
 
str8jacked23 said:
T-400 is painful!
Exe-not needed
Clomid is PCT
This cycle will not yield great results, especially for a beginner. Sorry.
Click to expand...

Agree 100% I don't get why people get test dosed that high, t-400 will leave you sore for a few days, If this is your 1st time pinning, you might want to invest in a heating pad. Also t-400 is a bitch to draw. And, You are gona need more pinz. I will draw with one, and replace it with a new one. There dirt cheap. For me I run test-e at a min of 750mg a week for at least 16 weeks. You won't get much off 400mg a week.

JP.
 
jp17815 said:
Agree 100% I don't get why people get test dosed that high, t-400 will leave you sore for a few days, If this is your 1st time pinning, you might want to invest in a heating pad. Also t-400 is a bitch to draw. And, You are gona need more pinz. I will draw with one, and replace it with a new one. There dirt cheap. For me I run test-e at a min of 750mg a week for at least 16 weeks. You won't get much off 400mg a week.

JP.
Click to expand...

400-500mg of test a week would yield good results for a first cycle.. I wouldnt recommend t400 at all cuz that wud fukcin hurt but if its all op could get his hand on 400 a week aint bad. He could split the doses 1/2cc twice a week
 
You must log in or register to reply here.
Back
Top