Sterilizing a vial

[CaptnCaveman]

Can anyone who sterilises their vials in the oven recommend a temp and time length?

 

[DetroitHammer]

I do 240 degrees for 30 minutes. But if you add the rubber stopper, then I do 220 for 30.

 

[CaptnCaveman]

Awesome, thanks man!

 

[IFNutrition]

It depends on the compound too. Tren will break down at a lower temp. So you can't go over 175 degrees I believe with Tren. All others should be fine at 240-250 degrees. Make sure you put a large gauge needle w/o syringe in the top of vial to vent.

 

[Blergs]

I would think the higher heat could damage the rubber no? get or borrow an autoclave > Invalid Link Removed IMO

 

[DetroitHammer]

He's talking about the vials. It doesn't matter what the temp is for the glass vials. The rubber is good at 220, but I hesitate to go any higher. I think you are thinking he is mixing the compounds. He's just sterilizing the glass and stopper, from what I understand.

It depends on the compound too. Tren will break down at a lower temp. So you can't go over 175 degrees I believe with Tren. All others should be fine at 240-250 degrees. Make sure you put a large gauge needle w/o syringe in the top of vial to vent.

 

[CaptnCaveman]

I did a half hour at 220 awhile back and it turned out fine. No issues with melting rubber or anything. Did have some spillage thru the needle which i assume is from the pressure increase tho. Prob lost a ml or so..