Researching about cutter

[SeaHawk22]

I was wondering what everyone would reccomend. I want to run mohn at 32-40mg a day and a low amount of 4-ad trans for a cutter. I was thinking of doing m1t low dose like 10mg but NOT at the same time as the mohn.

Now it would be nice to start off with the m1t and then go into the mohn, to have a nice kick start,
but

If I did this the m1t first I would shut myself down hard and then I would have to go the rest of the cycle suppresed. I was thinking if I ran the mohn first I would not be shut down as hard and then run the m1t for 2-3 weeks at the end.


Any help will be greatly appreciated thanks
SeaHawk22

 

[MakaveliThaDon]

check into some clen and T3 to run with that. You also might not want 4AD on a cut, as it will bloat you up. 4OHT would probably work better for a cutter. But definitely check into clen and T3 to run with that

 

[SeaHawk22]

check into some clen and T3 to run with that. You also might not want 4AD on a cut, as it will bloat you up. 4OHT would probably work better for a cutter. But definitely check into clen and T3 to run with that

Yea I was considering T3 as well. I assume cytomel we are speaking about. My only concern is that it will be too catabolic.

Again I am still researching so any input would be great, I have not even looked into peoples experience with running t3 with mohn.


SeaHawk22

 

[wastedwhiteboy2]

if you want to use the m1t use it at the end. I would use 40ht also. what about 1test?