Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

Ordered Too much Test-E

Socalmk6gti

Socalmk6gti

Active member
Ok so today half of my order arrived. 40ml of Test-E

I also ran by local store and got my ECA stack started.


Trying to cut as much as possible for 4 weeks before starting my first cycle. I'm currently between 15-17% BF.

So my original cycle was planned for 12weeks + break + PCT.

I Realizwd today that I ordered 40ml which is WAY more than I need

My question, should I start cycle sooner and do a cut then bulk? Drop ECA stack? Etc.

Looking for some legitimate advice

35 5'10" 212lb 15-17%BF. Trying to add muscle mass and cut body fat.

Been working out since high school, 1998, but been serious for past few years.
Thanks!

Still waiting on package 2 with ancillaries.
 
Ughh.. just stick to your plans. use what you need and save the rest for next time? Im sure you are going to do another cycle.. nobody is one and done no matter what you think.
 
Sounds good. I didn't realize I ordered 40ml of Test E.

Also, transferring from a sachet to a sterile vial. New needle into sachet, then same needle into vial? Or change needles twice per sachet? I just want to keep this as sterile as possible and trying to figure out how to do so. I have a bunch of 21/25g needles and want to do this as accurately as possible. Thanks. !!
 
40ml is only 10ml extra if your going 500mg 12 weeks.

Just run 750 for 12 weeks with a good ai eod.
Run your eca however long you want.
 
Socalmk6gti said:
Am I allowed to post pics of my gear? It's so stealth it's incredible. I'm seriously impressed. Gonna transfer to vials tomorrow. I have so much extra I might just pin 250mg to see how it feels hahahaha. Short term TRT pre-cycle? Muahahahahaha
Click to expand...
Why do you want to show le how your gear looks? Don't be an un intentional snitch.
 
Socalmk6gti said:
Sounds good. I didn't realize I ordered 40ml of Test E.

Also, transferring from a sachet to a sterile vial. New needle into sachet, then same needle into vial? Or change needles twice per sachet? I just want to keep this as sterile as possible and trying to figure out how to do so. I have a bunch of 21/25g needles and want to do this as accurately as possible. Thanks. !!
Click to expand...
You're making this shiit way to complicated bud.
 
brofessorx said:
40ml is only 10ml extra if your going 500mg 12 weeks.

Just run 750 for 12 weeks with a good ai eod.
Run your eca however long you want.
Click to expand...

250mg/ml x 2 pins/week = 8ml/month

12 weeks = 3 months = 24/ml

I have 40ml so I was contemplating a way to use the extra 16ml during this cycle by extending cycle or increasing dosage. That's all, thanks.
 
Socalmk6gti said:
250mg/ml x 2 pins/week = 8ml/month

12 weeks = 3 months = 24/ml

I have 40ml so I was contemplating a way to use the extra 16ml during this cycle by extending cycle or increasing dosage. That's all, thanks.
Click to expand...
This must be your first cycle
Your numbers reflect a perfect universe
You need 30ml for a 10 week cycle. Unless your source likes to over fill, but then I wonder about quality.
 
You should ALWAYS have more than needed because you will loose some every time you pin as some oil will get stuck in the dead spot at syringe tip unless you use slin pin which will reduce wasted amount.

I'd rather have extra than not enough
 
Yup, I always get an extra vial of w/e.

I'd rather not have the stress of measuring in order to hopefully have enough to get me through.

So much easier to just pull around what you want, then inject.

I got other shiit to worry about, like what to eat next.
Invalid Link Removed
 
Joedoubledose said:
You know what best bet may be to just send that extra vial of test e so I can hold onto it for you
Click to expand...
Unspoken forum rules, post 4 gets any an all extra gear for proper disposal
 
You must log in or register to reply here.
Back
Top