My Friggin Needles are stopped up

[hughes14]

I'm usin test suspension EOD at 1ml per shot. The thing is when i try to inject the plunger won't go down at all like the needle is clogged up. Its a 22g needle so it should'nt do this. It doesnt do it every time, jus sometimes an i can't figure out why.

 

[Bigblondekid]

You're not re-using pins are you? That **** is dangerous, just look at Gregg Valentino. Suspension should be tougher to push through in any pin though, I would think that with a 22g you'd be fine but you might try heating it up before pinning. Maybe put it in a hot water bath for a little while, should help to thin it a little bit.

 

[Frank Reynolds]

You're not re-using pins are you? That **** is dangerous, just look at Gregg Valentino. Suspension should be tougher to push through in any pin though, I would think that with a 22g you'd be fine but you might try heating it up before pinning. Maybe put it in a hot water bath for a little while, should help to thin it a little bit.

Thin what? Water?

Do you pull back on the plunger when it stops up, and see if that clears it?

 

[hughes14]

Yea it does nuthin. The suction from pullin it back jerks the plunger right back to where it was when i let loose.