Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

mdien oral suspension/solution?

t_dot_porkchop

Board Supporter
hey everyone,

ive been browsing this site for a while..really great information and knowledge on here (BTW: sledge rocks!). im a mod on another forum, but i never really got involved in any homebrewing. i wanna run a mdien cycle, but buying the tabs would cost too much as a decent dosage. has anyone tried running mdien in a solution or suspension like you can do with M4OHN? if so, how did you go about it (ie PEG-400 or olive oil/BA/BB method)?

thanks
 
Hi t_dot, I recognized your name & avatar from the other board. I ran across this statement in a lame thread on another board:

I've recently been told to use 499ml of peg400 1gm of methyldien and heat it over low heat for 30min.
Click to expand...
I don't know if it's valid or if it's any help. Just thought I'd throw it your way in case it is helpful.

dd
 
i thought about that PEG400 mix only, but that would cost about $120 in PEG-400 alone!!!

here is another question: do you need a permit or license or something to buy solvents like BA, BB or PEG? can i buy them from chemical supply places with no porblem?
 
Check these guys out. I've never used them myself, but tons of people on this board use them with confidence.
Invalid Link Removed


Here's a thread from the "Supplies" section of this board that has info on this very subject.
Invalid Link Removed

Again, I hope this helps.

dd
 
I just used olive oil. Bought a 500ml bottle of olive oil and put 1 gram of MD in it for a 2mg/ml solution. I baked it for 20min at around 200 degrees, the lowest setting on my oven for it to dissolve completely.
 
R6Speed said:
I just used olive oil. Bought a 500ml bottle of olive oil and put 1 gram of MD in it for a 2mg/ml solution. I baked it for 20min at around 200 degrees, the lowest setting on my oven for it to dissolve completely.
Click to expand...
and your results?
 
R6Speed said:
I just used olive oil. Bought a 500ml bottle of olive oil and put 1 gram of MD in it for a 2mg/ml solution. I baked it for 20min at around 200 degrees, the lowest setting on my oven for it to dissolve completely.
Click to expand...

I was planning to do the same with my gram.
 
PEG400 mix in 100ml for a 10mg/ml solution. You will need to heat it. I baked mine in the oven at 225 for 30 min shaking occasionally. Worked beutifully.

And definitly get your PEG400 at lemelange. I have seen the prices some sites sell it for :rolleyes: and for only 50ml. :eek:
 
Lean One said:
PEG400 mix in 100ml for a 10mg/ml solution. You will need to heat it. I baked mine in the oven at 225 for 30 min shaking occasionally. Worked beutifully.

And definitly get your PEG400 at lemelange. I have seen the prices some sites sell it for :rolleyes: and for only 50ml. :eek:
Click to expand...
that looks like a great plan...have you done it already? what were your results at 10mg/ml?
 
t_dot_porkchop said:
that looks like a great plan...have you done it already? what were your results at 10mg/ml?
Click to expand...
Oh yeah, I did it already. I was cutting and I used 20mg/day. Kept all my strength and got down to 5% BF :cool: Depending on your experience with theese compounds, and wether or not you are bulking, your results could be diferent. I think the consensus is that M-Dien is better for cutting. It's not a potent mass builder like M1T is. That desn't mean you can't make some good gains if you have your ducks in a row though. ;) Good Luck.
 
20mg/day...did you have any sides? stack with anything? i was thinking of running the MD as a cutter/muscle preserver during the summer and then fall into som M1T/4-AD for the fall/winter.
 
t_dot_porkchop said:
20mg/day...did you have any sides? stack with anything? i was thinking of running the MD as a cutter/muscle preserver during the summer and then fall into som M1T/4-AD for the fall/winter.
Click to expand...
I ran it solo and I had no sides at all except minor acne and a loss of libido after a couple weeks.(tranz 4AD can take care of that easily though.)
 
Lean One said:
PEG400 mix in 100ml for a 10mg/ml solution. You will need to heat it. I baked mine in the oven at 225 for 30 min shaking occasionally. Worked beutifully.

And definitly get your PEG400 at lemelange. I have seen the prices some sites sell it for :rolleyes: and for only 50ml. :eek:
Click to expand...


Do you bake it in the Lemelange bottles (top off of course)?
 
SJA said:
Do you bake it in the Lemelange bottles (top off of course)?
Click to expand...
Nope. They are plastic. I used a small glass bottle like the ones that you get vinegar and salad dressings and such. Top off of course. :)
 
You must log in or register to reply here.
Back
Top