Making 1 test Cyp

resurrected

New member
Anyone have any recipe for making injectable 1 test cyp? I have 20 grams of the stuff I want to use up.
If not injectable, could it be used dermally with dsmo?
Either way as long as i can use it up and get some results from it.
 
Then maybe I should ask this, How much ba, bb is used in the mix. 2.5% ba and 10 % bb? I will use 10 grams of it, sound right?
 
I will help you out... but why on earth would you order 20g when you ask the question can a ester'd test be used in a transdermal? :trout:

EDIT: I posted some directions below... but if you read the stickied threads by Kitchen Chemist... should give you a good idea of the process.
 
To answer your question... 2% BA and 20%BB, you will find these common ratios for most hormones.

NOW....

I will go ahead and post full instructions and won't assume you know anything.. especially with the Cyp to dermal question... :think:


From the Chaos school of homebrew.

This is a very general step through of the brew process.


SUPPLIES
Powder
Benzyl Alcohol
Benzyl Benzoate
Cottonseed/Sesame/etc. oil
Vials
18g needles
23g needles
60cc SYRINGE
3ml syringe
20uf whatman filter
Alcohol pads
Beaker
Scale (if you need to measure your powder)

STEP 1
Add the powder to your beaker.

STEP 2
Add your Benzyl Alcohol to the beaker containing the powder.

STEP 3
Add your Benzyl Benzoate to the beaker containing the powder.

STEP 4
Heat the beaker until all ingrediantes are dissolved and there is no swirling. I use two different methods depending on batch size and how lazy I am at the moment:
Oven set to 250 degrees.
Hotplate (heats the solution to about 275 degrees)

Stir or gently revolve the solution occasionaly.

STEP 5
After everything is dissolved and there is no swirling, I like to heat for 20 minutes. at least 10 minutes is suggested.

STEP 6
Add your oil and heat until there is no swirling.

STEP 7
Heat an additional 20 minutes.

STEP 8
You will want to let it cool a little bit but not much. Having the solution warm makes it easier to run through the syringe filter. Put a 23g needle into one of your empty vials to release the pressure as you put the solution into it. Now put the syringe filter on a clean 18g needle and insert in the vial. Use a DIFFERENT 18g needle to draw up the solution from the beaker. DO NOT DRAW UP THROUGH THE FILTER.

STEP 9
Now remove the needle used to draw up the solution and attach the syringe to the filter and needle that are already in the sterile vial. Go ahead and push down on the plunger to run the solution through the filter into the vial. ( a chaulk gun makes this part easier)

STEP 10
After you have ran all of your solution through the filter remove the syringe from the filter and draw about 10ml of air into it. Reinstall the syringe on the filter and push the air through to purge the filter. You cannot get all the solution out of the filter but you can get most of it.
 
Thanks but I do realize that it cannot be used for transdermal. I guess I was just looking for a way to get rid of it somehow.
As for making it, the only real question I had was the amount of ba and bb in the recipe. I have made a few batches of fina in the past with great results, but was not too sure if this would be the same.
Sorry for being a pain in the ass,
 
You must log in or register to reply here.
Back
Top