is it possible to take cytomel with Mechabol?

Prodogy

New member
First off the resaon why I was unable to post this in the Anabolics section was because it would send me to another page where it says the admin wants you to view this page before going to the forum, after I viewed that page I go back and it just kept on sending me there so I said screw it.


So I am 23 years old and I have set my mind on starting a cycle of Mechabol looking something like this:75/75/100/100/100/100.
I will be running cycle assist and milk thistle and for PCT I will have Clomid 100/100/50/50. Obviously my diet will be intense but I am still working that part out.

My question is: is it possible to take T3 ( cytomel) with my first PH cycle and see good gains while seeing a decent amount of fat loss? ahhh yes feel free to add anything onto my mechabol cycle thx!
 
Im running it like this.
75/100/100/100/100/125 mecha
0/600/600/800/800/800/1000/1000 stano
 
If it's your first cycle then those doses are fine. Don't use the T3 as mechabol won't be enough to stop the muscle loss. If you are looking to increase fat loss then add in Stano as hvatech is running. Start the Stano at 600mg for the first 2 weeks and then increase to 800mg if you don't have any adverse effects so you would end up with:

Mech - 75/75/100/100/100/100
Stano - 600/600/800/800/800/800
 
Prodogy said:
this is my first cycle, i dunno you think the numbers are too low? Is this your first cycle?
Click to expand...

Yup first one. Your numbers are fine. As far as potency I can't compare but I'm up 16lbs in week 3.5
 
warsteiner said:
If it's your first cycle then those doses are fine. Don't use the T3 as mechabol won't be enough to stop the muscle loss. If you are looking to increase fat loss then add in Stano as hvatech is running. Start the Stano at 600mg for the first 2 weeks and then increase to 800mg if you don't have any adverse effects so you would end up with:

Mech - 75/75/100/100/100/100
Stano - 600/600/800/800/800/800
Click to expand...

This isn't true...look up pyrobatts thread/log on it
 
You must log in or register to reply here.
Back
Top