Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

first time pinning with equipoise question

can_o_whoop_ass

New member
Hi guys, I've done several m1t, m4ohn cycles as well as other various prohormones, I have just gotten hold of enough equipoise to do a 12 week cycle....injecting for the first time, my question is would it be worth adding some M1T and if so how much and at what point, or should i just do an eq cycle only? :think:
 
how about getting some test and doing a typical newbie cycle :rant: EQ only cycles rarely get anyone great resutlts it seems.
 
Im not in favor of stacking ph with aas. If you're gonna shoot up with eq, might as well try to get your hands on some test to stack eq with. EQ does wonders for some when stacked with other compounds but eq alone wont result in too much. Test enan/cyp 500mg - EQ 400mg/week..... nice
Sage
 
sage said:
Im not in favor of stacking ph with aas. If you're gonna shoot up with eq, might as well try to get your hands on some test to stack eq with. EQ does wonders for some when stacked with other compounds but eq alone wont result in too much. Test enan/cyp 500mg - EQ 400mg/week..... nice
Sage
Click to expand...

Ok guys thanks for the replys, I'll try to get hold of some Test, but cost may be an issue and the fact I've got **** loads of m1t kicking about I thought I could kill two birds with one stone
 
get some powder and make your own. test is about $1 or 2 a gram. your stuff is guaranteed to have the amount it says it does! and more importantly, no crap in it!

fiddler
 
fiddler said:
get some powder and make your own. test is about $1 or 2 a gram. your stuff is guaranteed to have the amount it says it does! and more importantly, no crap in it!

fiddler
Click to expand...

sounds good to me fiddler, can you tell me where to get the info on how to make my own? :thumbsup:
 
go back to the main page where the listing for all the different forum subjects are. go down a bit and you will see conversion. there should be some stickies in the forum on the procedure.

i'll give you the gist of it. measure stuff into vial. mix. filter. bake. done. just make sure you figure out how to the powder calculator. it makes it idiot proof. doing your own calculations can mess things up.

maximum, all you really need is 2-3%BA and 6-7%BB. so adjust accordingly.

fiddler
 
You must log in or register to reply here.
Back
Top