Filtering into smaller vials?

LilDon

New member
I have 50ml of Test susp+prop 200mg/ml in a 50ml lotion bottle (IP) and I'd like to filter it into smaller vials(20ml) and dilute it to 100mg/ml with cotton seed oil.

Do I need to use a fresh syringe filter for each vial?
Also, should i filter in the test than the oil or should i filter the oil first?

Thanks
 
size said:
read this thread:
Invalid Link Removed
Click to expand...

Maybe I'm not reading it right but it doesn't seem to explain if I should use a fresh filter or not... Just says you can reuse the needles when filtering (one needle for each type of gear).
Help?
 
kwyckemynd00 said:
I'd use one filter per compound.

I.E. if you have EQ & Test, have to filters.

JMO.
Click to expand...

So in my case I would only need one filter to filter the 50ml of Test into five 20ml vials?

Thanks for the quick response guys :wave:
 
sounds good to me, bro, best of luck......and be sure to deal with the pressure issue when you're transferring.

I.E. If you pump out 25mL of oil from the 50mL bottle and do not replace that 25mL with air, you're going to have a screwed up pressure situation and it may take you an extremely long time to transfer.

Same goes with adding to vials. If you add oil, remove air, etc.
 
kwyckemynd00 said:
sounds good to me, bro, best of luck......and be sure to deal with the pressure issue when you're transferring.

I.E. If you pump out 25mL of oil from the 50mL bottle and do not replace that 25mL with air, you're going to have a screwed up pressure situation and it may take you an extremely long time to transfer.

Same goes with adding to vials. If you add oil, remove air, etc.
Click to expand...


'k gotcha- I'll stick a 20g needle in the rubber stopper when I'm drawing out the oil/gear or filtering into a vial.

Thanks!
 
You must log in or register to reply here.
Back
Top