Cut stack help

[jamesm11]

I'm finishing up my sdrol and katanadrol 2.0 PCT right now. Looking to jump into an all out cut to drop off the remaining bf and really tune up.

I'm wondering what's a good stack to use? I don't want clenbuterol due to the shakiness I get. I am fine with ECA and have done it before.

Is there anything better than ECA? T3?

Thanks for the help

 

[jamesm11]

I'm just coming off my PCT so I need to wait at least 6 weeks before I cycle on again. Therefore winni would probably be a no-go at this time. Anything else?

EDIT: This was a reply to someone above who was deleted by mods.

 

[kevinhy]

So you are at least four weeks out from cycle?

As long as thats the case, you could always try something like Alpha-t2 or the AT2/OEP stack. Something about ECA rubs me the wrong way, so i often opt for the "less sides" route.

 

[Ajerone]

As said above if your a few weeks out from cycle, my favorite cut stack consists of some combination of the following:

E/C
Lean Xtreme
DCP
HEAT/AlphaBurn

I like cortisol control towards the end of a cut, alongside something like Abliderate/ Eviscerate depending on target areas and BF%.

 

[jamesm11]

yeah i went with

AT2
E/C
Eviscerate
Erase
Anabeta
DCP

Yeah it's a lot but this is my last push. I'm doing some modeling and need to cut some bf. I'm at 10-12 and want to get around 8