Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

bold acetate - when it holds?

daemonium

New member
I have made some bold ace but it crashed @ 100mg/ml! Any of you guys have sugestions for the average concentration it will hold?
anyone here brew this stuff?
 
are you asking because to check it minimally for beeing real bold ace or because you think i might putted in solutin wrongly?

actually I didn't, I know that it has a high melting point, and it was a pain in the ass to put it in solution....

maybe I'll try first to put it in the oven @ 155ºC before lowering the concentration...
 
I have heard that bold ace is a pain in the ass to convert. Also you need to know that the shorter acting boldenones like prop and ace cause allergic reactions to most people. I got it from bold prop and it was like a 24 hr flu plus my leg felt like it was going to fall off for a week. I have heard people using ethyl oleate as a carrier for bold prop without allergies, but dont have the recipe. Be careful!
 
I've heard it too and some guys got that! because of that this powder was almost offered lol

I wouldn't put this stuff in my quads that's for sure!

Yes, I just waiting for some EO too, to convert it, more for the pain than else!
This stuff was hard to dissolve tough...

I is a bit hard to have some good help, because not a lot of guys dealed with bold ace and prop! including myself...
 
daemonium said:
are you asking because to check it minimally for beeing real bold ace or because you think i might putted in solutin wrongly?

actually I didn't, I know that it has a high melting point, and it was a pain in the ass to put it in solution....

maybe I'll try first to put it in the oven @ 155ºC before lowering the concentration...
Click to expand...
because I know of a couple of cases that the powder that was recieve was ether a. bold base or b had about about 25% bold base content. ether would be a. very painful to inject regardless of mg/ml and b. almost imposible to get into solution with oil. bold ace is a pain in the ass anyway, if you want a short acting bold product use a cyclodextrin carrier. but to answer your question you should be able to get into solution at around 75mg/ml. granted this was done with homemade bold ace and in a "nice" setting. your going to have to use more BA then you would like, 5% min and 10% preferably (be careful, some people find 10% ba painful, it doesn't bother me much at all and 7.5% is fine for me)
 
You must log in or register to reply here.
Back
Top