Guest viewing is limited

anyone of you guys draw with 23 gauge? possible?

DoubleP

DoubleP

New member
Hey guys,

Got a **** ton of 23 gauge needles dropped off. Is it possible to draw with a 23 gauge? I know I'll be injecting with them...but any of you draw test with them?

Thanks
 
Same with me I bought a box of 23g I draw with 23 then get a new one to use to inject. Drawing just takes a lil time but has worked for a year for me
 
Set your vial on a heating pad and let it thin a bit
 
Heating it? Does that weaken the test at all? Amateur question but I never graduated chemistry class ;)
 
Heat about an inch of water in a coffee mug in the microwave and let the vial sit in it for 4-5 minutes. Thins it out a little, easy to draw with a 23. Also if the oil is thick, shoot a little air into the vial. It will create a vacuum and push oil back into the syringe.
 
DoubleP said:
Heating it? Does that weaken the test at all? Amateur question but I never graduated chemistry class ;)
Click to expand...

No. Not any amount of heat you could safely generate. You're good bro. Any of these techniques will work fine.
 
You can certainly draw with 23g, but for that amount, it is going to take a longer time than I'd have patience for. Can't you pick up some 18g? They are super cheap and really fast for draw.
 
DoubleP said:
Hey guys,

Got a **** ton of 23 gauge needles dropped off. Is it possible to draw with a 23 gauge? I know I'll be injecting with them...but any of you draw test with them?

Thanks
Click to expand...

I draw and inject everything with 25g needles two different ones for drawing an injecting, but both are 25g

No issues just takes about a minute to pull 2cc's
 
So my test is BOSS lab, 250 mg in a 10 ml bottle.....I'm doing a beginner cycle so 250mg twice a week. Hoping to get results with 500 mg a week. My syringe is obviously listed in ML measurements....I'm thinking 1 ML =250mg. Am I correct then to just draw 1ml per pin? 1 ml twice a week = 500mg a week.
 
DoubleP said:
So my test is BOSS lab, 250 mg in a 10 ml bottle.....I'm doing a beginner cycle so 250mg twice a week. Hoping to get results with 500 mg a week. My syringe is obviously listed in ML measurements....I'm thinking 1 ML =250mg. Am I correct then to just draw 1ml per pin? 1 ml twice a week = 500mg a week.
Click to expand...

Yes you are correct
 
You must log in or register to reply here.
Back
Top