A few questions on measuring out some gear

[dialtone]

My desired dosages don't really match up with the dosages of my stuff. What is the best way to measure it out as needed? Just want to make sure I go about this the right way:

Test E is dosed at 250mg/Ml, but I would like to draw 300mg (x2/week).

Tren A is dosed at 100mg/Ml, but I would like to draw only 75mg

Is there some sort of standard way to adjust this?

Thanks!

 

[boxer78]

For the test, you'd draw 1.2 ml. That is 300/250. For the tren, you would draw 0.75 ml. That is 75/100. Basically, you take what you want in mg, divide it by the mg/ml, which will give you the ml to draw.

mg/(mg/ml) = mg*(ml/mg) = ml

 

[dialtone]

For the test, you'd draw 1.2 ml. That is 300/250. For the tren, you would draw 0.75 ml. That is 75/100. Basically, you take what you want in mg, divide it by the mg/ml, which will give you the ml to draw.

mg/(mg/ml) = mg*(ml/mg) = ml

Cheers mate! Just what I was looking for.

 

[boxer78]

Cheers mate! Just what I was looking for.

No worries bro, good luck on the cycle!