1AD M1T Question

Thesticles

New member
I have a 1AD/4AD cycle planned out and am about half way through. I am using moderate doses for a 6 week cycle started with 300/300, and bumped to 600/600 with a 4AD preload the week prior, have proper PCT all arranged.

I am not seeing much in the results department. My choices are to bump up again (rather not) wich will shorten my cycle length, ride it out with minimal results, or I have some M1T to add.

Question:
Would adding a reasonable dose of M1T for the last 2 weeks be a good idea. I have done M1T before and had good results at 5mg for 3-4 weeks. I get regular blood work, diet is in good shape, and training is solid.

I am really wanting to know how M1T and 1AD would get along. Would there be any problems, other than liver toxicity wich I am not too concerned with as they are both low doses and I supliment and monitor liver health regularly.

Info:
5'4" 195
Lifting 16yrs, some competitive PL (natural) in early 20s
Hormone/Steroid exp ~3yrs

Thanks for any constructive feedback,

Thest
 
mixing 1AD and M1T

Bump..

I got nothing over on the other message BBoard, but was hoping I could get some comments here.

Anyone???
 
stacking m1t and 1-ad is pointless. m1t and 4-ad would be good, though.
M1T = Methyl 1-Testosterone
1-AD = converts to 1-Testosterone
 
Thanks for the reply Oldspice.

The problem is that I am midway throught a 1AD/4AD cycle and am not very pleased with 1AD.

Do you think I should just switch out the 1AD for M1T and continue cycle?
 
600mg is far too low a dose of oral 4AD that you will likely see nothing at all from it. Oral 4AD need be dosed very high for effectiveness.

600mg of 1AD is a good place to start off but likely at your size will not provide much until the third or fourth week.

Remember both of these are oral and have to convert and your doses are quite low.

BTW:
1Test, 1AD (converted to test) and M1T may be 'theoretically' the same but they do not act as such in your body.

The conversion of 1AD to 1test is not the same as 1test. It should be theoretically but real world shows a bit different response.

M1T is by no means in the same catagory as 1Test. Though it is technically methylated 1-test, the methylation renders it a completely different compound.
 
Thank you both for the info.

I still have a question though, can I add M1T to the cycle in addition to or in place of the 1AD, as I will not have enough 1AD to increase again or run the full lenth?

Or would I be better off finnishing out a weak cycle and trying again after time off?
 
You must log in or register to reply here.
Back
Top