1-test cyp at 200mg/ml

spoofy

Member
So I was wondering if I can simply use bigcats approach at making the injectable?
all the kits I see only do 100mg/ml

5 grams at 200mg/ml = 25ml

3% of 25ml = .75ml (amount of Benzl alcohol to use)


Fill container with 25ml of water and mark line.

Heat sesame oil 212F then let it cool a bit
dump powder in container and then add oil to just below the line
add .75 of benzyl alcohol

if line is not reached add oil as needed.

shake up and enjoy

1-test 35$ for 5 grams
cost of oils + vial will be like 3$
total cost would be something like ~45

Would this method work for both 1-test cyp and 19nordiol cyp and be burn free?
 
There are important steps that are not present in your brief procedure.

It is imperative that you filter the brew and heat shock to ensure sterilization. Other than that, I would add 5-10% BB to the recipe since the specie has a cypionate ester attached.

Chemo
 
Chemo said:
There are important steps that are not present in your brief procedure.

It is imperative that you filter the brew and heat shock to ensure sterilization. Other than that, I would add 5-10% BB to the recipe since the specie has a cypionate ester attached.

Chemo
Click to expand...

I am a newbie at this ..could you explain how I would go about filtering and heat shocking the brew? as you can guess i want to make sure i get everything right :D

I just took bigcats write up on making test eth powder into an injectable and changed some numbers around. would you consider this a good method for making an injectable (for someone new to this)?
 
spoofy said:


I am a newbie at this ..could you explain how I would go about filtering and heat shocking the brew? as you can guess i want to make sure i get everything right :D

Click to expand...

You simply run the mixed solution thru a whatman filter. Since this is going to be the finished product, you will want to filter it into a sealed sterile vial. You then place the vial in a 200 degree oven for 15 minutes, take it out of the oven and let cool. Repeat again two more times.
 
Shouldn't you be venting the sealed sterile vial w/ a sterile 20 gauge needle when you're "heat shocking" it?

~Todd
 
Yes, you should vent when heat shocking and also when filtering the final product into the sterile vial.
 
You must log in or register to reply here.
Back
Top