Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

is it possible to esterise bulk powder?

Stavross

Stavross

Board Supporter
Anyone know if there is a way of converting 4-OHT powder into an ester? I'm thinking like a 4-oht cypionate?

I'm sure it can be done but is it something that would need an elaborate lab set up?:ntome:
 
Stavross said:
Anyone know if there is a way of converting 4-OHT powder into an ester? I'm thinking like a 4-oht cypionate?

I'm sure it can be done but is it something that would need an elaborate lab set up?:ntome:
Click to expand...

Its possible with the right reactants, but I would consult skye, karius or Dr.D for this type of information.
 
Even with a cypionate ester it will not go into solution and not hurt at anything over 35mg/ml. When I used OHT base I had an oil based solution of 30mg/ml. so IMO it is better to make an oil based solution with what you got or try to make a water based suspension, which would probibly be better.
 
So an oil base solution with the straight 4-oht. ? :)

Thanks for the info mate.

How often were you jabbing it?
 
I did it every day to every other day, they would always be 3ml shots so it would take a couple of days for the oil to absorb. I did 30mg/ml in oil strait. I also did 50mg/ml but it would crystalize so I heated it before each shot and mixed it with other stuff in the pin so it wouldn't hurt so bad. It was a pain in the ass with all the oil I had to shoot but I realy liked the results.
 
its possible but its a pain in the ass. I have made test laurate before and it works but I need to refine the process. look up fisher reactions.
 
You must log in or register to reply here.
Back
Top