Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

HCG dose help

Bcuzimbatman

Member
Coming up on week 5 of my Test E cycle and am going to start administering HCG sub q injections. I purchased slin pins for shots in the stomach but am having a hard time figuring out where to pull to. I've used a calculator to determine that on a regular needle I would pull back to .5ml to achieve the goal of 250iu but my slin pins show units instead of ML so I have no idea how to convert them. Anyone have any experience with this?
 
0.5 mL on the slin pins would be 50 units.

Are you sure you did your math right? Either you did your math wrong or you used way too much bac water. How many IU's is your vial and how much bac water did you use? 0.1 mL of bac water per 250 IU of hCG would have sufficed.
 
mike33511 said:
0.5 mL on the slin pins would be 50 units.

Are you sure you did your math right? Either you did your math wrong or you used way too much bac water. How many IU's is your vial and how much bac water did you use? 0.1 mL of bac water per 250 IU of hCG would have sufficed.
Click to expand...

Well the vial with HCG powder is 5000 and the water is 10ml. When I mix the calc I used shows a .5ml pull
 
mike33511 said:
0.5 mL on the slin pins would be 50 units.

Are you sure you did your math right? Either you did your math wrong or you used way too much bac water. How many IU's is your vial and how much bac water did you use? 0.1 mL of bac water per 250 IU of hCG would have sufficed.
Click to expand...

Haven't mixed yet so if that math is correct for a 5000 bottle of HCG I only need 2ml of water?
 
or you could use 5ml of bac water when you mix and you would only have to draw 25 in a slin to get your 250iu
 
You must log in or register to reply here.
Back
Top