Can somebody?

[vicmack777]

Please point me in the direction to a good post about mixing powders and peg 400. Something with heating instructions and what not. Thanks in advance.

 

[Billy the kid]

Directions for Oral solutions:



Method 1 - Olive Oil Oral Solution 10mg/ml

(For M1T and M4AD only)

• 1gm M1T
• 96ml extra virgin olive oil
• 1ml BA
• 2mlBB
• Heat for 10 min and let cool and you have a 10mg/ml solution.

Method 2 - Everclear or Bacardi 151 Oral Solution 10mg/ml

(For M1T and M4AD only)

• 1gm Methyl-1 Test powder
• 99ml Everclear or 151
• Allow to dissolve.

Method 3 - ( For M5AA, M1T, M4AD)

• 1 gm powder
• 25 ml Peg 400
• 73ml Propylene Glycol
• Heat for 15-20 min and let it cool before use. Methyl-5AA may need to be heated slightly before use.

Method 4 - (For Methyl 1,4 ADDiol)

• 99ml PEG 400
• 1 Gram Methyl 1,4ADD
• Heat for 10 Minutes in a water bath
• Yields 100 10mg/ml servings

 

[vicmack777]

Thanks for the post Billy. But what should I heat it on (stove, microwave?) and at what temp?

 

[Billy the kid]

I normally just use hot water from my sink. But you can boil the water if needed.

Boil some water on the stove. Take the pan off of the stove and put the bottle in it for 5 minutes. Swirl the bottle around and shake it a little. Heat the water back up and warm up the bottle some more. Do this until the powder is dissolved.

Dont go putting the bottle on the stove or in the microwave.
Just heat it with hot water and reheat the water as needed.