Test Suspension (25 gauge too small)

  1. Test Suspension (25 gauge too small)


    I am confused. I was under the impression that test suspension could be injected with a very fine needle. It is impossible to draw the suspension with a 25 gauge while I have heard of it going through a 27 gauge. Should I just get larger needles or is my vial questionable? Thanks.


  2. Quote Originally Posted by PIOTREK
    I am confused. I was under the impression that test suspension could be injected with a very fine needle. It is impossible to draw the suspension with a 25 gauge while I have heard of it going through a 27 gauge. Should I just get larger needles or is my vial questionable? Thanks.
    you should be able to inject with a 25 guage. It is also possible to draw with a 25 guage but it takes a while. Draw with a larger needle like a 20guage or so.

  3. Alot of guys I believe use different needles for drawing and injecting.

    I admit i've never experienced the dark side before, so I might be talking gibberish, but I have done my fair share of reading.
    •   
       


  4. Its not that its taking too long to draw the test, the liquid will not enter syringe AT ALL. Some will get stuck in the needle and it will be plugged.

  5. if its oil based then a bigger pin will be needed, water based=smaller needle

  6. only micronized test suspension will fit through smaller pins. if you got some UG Tsusp made in a bathtub, then the powder isnt likely micronized and will require, apparently, a 23g or smaller to flow.

    next time ask your source beforehand. 23g sticks ED or 2x/d is no fun.

  7. My source has waterbased suspension that will go through a slin pin...

  8. Quote Originally Posted by Jaxxxon
    My source has waterbased suspension that will go through a slin pin...
    yeah, about half will. if i am dealing with a new source, i always ask his customers if his Tsusp will fit through a slin pin.

  9. I know better to ask for micronized suspension for next time. I believe "univet's" suspension is micronized. At any rate, I have ordered some 23 gauge syringes. If it still wont flow, I will return the vial.
  

  
 

Similar Forum Threads

  1. 3cc 25 gauge 5/8 No good for test enanthate?
    By Matty90 in forum Anabolics
    Replies: 12
    Last Post: 05-28-2012, 12:04 PM
  2. WTF, can't draw Test Ethan from a 25 gauge pin!
    By habit50 in forum Anabolics
    Replies: 26
    Last Post: 09-06-2006, 04:24 PM
  3. who has run test suspension?
    By hethcliff in forum Anabolics
    Replies: 9
    Last Post: 03-14-2005, 03:17 PM
  4. Replies: 8
    Last Post: 02-17-2005, 06:15 PM
  5. Test suspension....me likey..:-)
    By lifted in forum Anabolics
    Replies: 17
    Last Post: 07-31-2004, 01:25 AM
Log in
Log in