Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

Saturation Question

warnerve

Well-known member
Quick question for you transdermal gurus...I recently started using Nutraplanet's penetrate with 4ad in and i think i may have oversaturated it by a few grams as I measured rather inaccurately. Does this mean that the whole batch is bad or that some is just going to waste? Not too concerned if it means some is going to waste as I wasn't plan on using the leftover 4ad anyways. Thanks in advance guys.
 
If all the powder you put into your carrier is disolved, then no worry it's good to go . Just modify your dosage (in term of ml/day) to match the new concentration and use it.
 
You also try CAREFULLY heating it, if there is some powder undissolved.
 
dsade said:
You also try CAREFULLY heating it, if there is some powder undissolved.
Click to expand...

What is the best way to go about heating it? I have given it numerous hot water baths too. I think I have just saturated it as much as it's gonna go, it looks mostly dissolved and just feels a little grainy when i put it on, like there's just a little that didn't dissolve. Thanks for the help guys.
 
Do you know how many grams of PH you put in 4OZ carrier?
If you have any carrier left you can add some to your mix and heat it.
Generaly I don't go over 50-60mg/ml of carrier.
 
Hot water bath is the safest...so if you have already done that, the dilution method above would be the best.
 
You must log in or register to reply here.
Back
Top