Guest viewing is limited

Needle Size's...

tek

Member
buddy of mine gave me a **** load of 25gauge 1-1/2'' needles. i tried to pull out Test Enth this morning and it wouldt pull **** hahah. im guessing its too small of a gauge for that TEST.whats an ideal gauge for TEST ENTH ?? 23 ?? ill be going through the GLUTES. will the TREN ACE pull through on the 25 gauge needle ?? thanks guys
 
20 to draw 23 or 25 to inject. IMO
 
Just run the vial under hot water for a few minutes. However, a larger gauge will always be quicker for drawing.
 
thanks guys. ya a buddy of mine gave me a 23g to pull out. im kinda scared how the 25g is kinda flimsy for going into the GLUTES. hahah
 
Alexander said:
Just nuke your gear for 20 seconds, it'll pull and flow like wataaah.
Click to expand...

I don't recommend that. Who knows what effect that could have on the hormone. Just use warm water or a heating pad. I like to let the heating pad sit on whatever site I will be injecting while it warms the gear. That way I have lowered the viscosity of the oil and relaxed the muscle with one stone.
 
get 20g and draw, switch to 23g or 25g. 1.5" for glutes, 1" for everywhere else. This has been covered dozens of times.
 
i used to use warm water but i came up with using my girls hairdryer to get the job done. I just blow it on the side of the bottles for a bit, then draw. Then blow it on the side of the syringe. Then squirt a test drop on my hand to make sure its not to hot. Done
 
25gauge just scares me how flimsy it moves. but i got my GF to inject me last night. wast soo bad =]
 
more importantly... 90% of multi use vials over 5cc or so Ive seen have metal / aluminium seals... dont microwave metal folks tis bad :D
 
You must log in or register to reply here.
Back
Top