SeaHawk22
Member
- Awards
- 0
I want to make some 1-test cyp using the <<oil/solvent 100ml>> conversion from eagle. This seems the simplest.
I just want to make sure I am doing the conversion properily.
1. Mix the 1-test cyp with the oil/solvent.
***I have read some saying that 200mg/ml is too much and to stick at 100mg/ml. What is the general consenus?
2. Heat it up? Does this mean bake at 250 for 45 minutes? Or put it in boiling water?
3. Put a 28 gauge needle in a sterile 100cc bottle (so air can escape). Use a watman filter (what size??? .45??) and then run the solution throught the filter.
Is that it?
Any help will be greatly appreiciated thanks
SeaHawk22
I just want to make sure I am doing the conversion properily.
1. Mix the 1-test cyp with the oil/solvent.
***I have read some saying that 200mg/ml is too much and to stick at 100mg/ml. What is the general consenus?
2. Heat it up? Does this mean bake at 250 for 45 minutes? Or put it in boiling water?
3. Put a 28 gauge needle in a sterile 100cc bottle (so air can escape). Use a watman filter (what size??? .45??) and then run the solution throught the filter.
Is that it?
Any help will be greatly appreiciated thanks
SeaHawk22