Prop/Tren ace combo

Blue_moon

New member
Awards
0
Looking for any tips on homebrewing Test Prop and Tren Ace powder into a low dose injectable.
I have all the material:
BA
BB
Sesame HSP oil (clear as crystal and runny like water)
7g tren ace
10g test prop
6 x 50ml vials

Im wanting to brew this to a dose of 50mg test prop/ 35mg Tren Ace
My thoughts for 50ml:
4.25g of powders (1.75 Tren, 2.50 test)
10ml BB
1ml BA
39ml Oil

So, any thoughts, ideas, critics or suggestions are very welcomed.

Thanks
p.s. First cycle. Clomid and Nolva already on hand.
 

Blue_moon

New member
Awards
0
Yes, I posted there too. The more feedback the better, imagine that. :stick:
 

BIGAINS

Member
Awards
0
You could bump the doses up by 25% if you want a stronger painless product. At the doses you stated you could cut down on the amount od solvents you are using. 1% ba and 10% bb should hold it.
 
Ubiquitous

Ubiquitous

Registered User
Awards
1
  • Established
Im wanting to brew this to a dose of 50mg test prop/ 35mg Tren Ace
My thoughts for 50ml:
4.25g of powders (1.75 Tren, 2.50 test)
10ml BB
1ml BA
39ml Oil
.
You're also not taking into account the displacement of the powder. Dry powder displaces roughly 0.75ml per gram. You can also safely raise the concentration of said powders without crashing using those solvent ratios.. IMO. That is a low concentration and you'll need to inject 2cc's to get a reasonable dose.. therefore kind of making a blend redundant..as you'd get the same volume from using them individually. :)
 

Similar threads


Top