I did a bulk last year eating a few hundred calories over maintenance and went from 170 to 185 over a seven week span. im 5'8 just fyi. My waist size stayed almost the same and barely put on any fat.
Cycle was mecha at 100-125mg and stano at 800-1000mg
I want to cut this February and was wondering should I switch the stano out for something else to enhance the cut?
I have 8 bottles of mecha so I want to stick to using that.
I was thinking about 11-oxo, but some people said stano was still better because of the strength gains that come with it?
How are fat burning properties of 11-oxo? Will it make a big difference?
11-oxo will help drop a little bit of fat through its cortisol control properties. However it needs to be dosed in the 800mg-1gr range during a cut ot help preserve muscle and at that dose noticable fat loss should be apparent.
Peak Athletic Edge Training Inc - Training & Diet Programs
Specializing in Body Recomp, Weight Loss, and Conditioning For details, pricing, or general enquires feel free to send me a PM Antaeus Labs Rep! http://www.antaeuslabs.com/
I'd potentially say Epi due to it's AI like properties, but if you stack Epi and Mecha TUDCA is a must, I'd go for stano over 11-oxo to get effective dose's of 11-oxo it's dumb money and a stupid amount of pills or you could go prototype nutrition 11-spray but it's still dumb money.
Epi for like 30-40, mecha 75-125, and stano 800-1000
Transderm trenazone could be looked into as well.
I've seen some people even saying TUDCA is only needed for SD or stacks of methyls.
If you don't have your cycle support yet, look into milk thistle's effect on androgen receptors, then check out Anteaus Talos, Anteaus Aegis, and Liv.52(not the new Liver Care Liv.52 can be had for dirt cheap like 5 dollars for a 100ct).
If your used to running standard cycle support you could just add in bulk TUDCA nutra has a pretty good deal on a 60ct, I believe daily dosage is 500mg. So 6 week cycle 2 bottles.
op cut with mecha and masteron, best stuff money can buy
Between stano and trenavar to stack with mecha...which one would y'all pick to make a cut as effective as possible?