1st H-DROL Cycle help!!!!

  1. 1st H-DROL Cycle help!!!!


    Hey guys looking to start an h-drol cycle. After my research I'm thinking that it would work best for my situation. This is my 1st ph. I am 21 yrs old 6ft 2in 180lbs. I take in about 250-300g protein and carbs a day. Been lifting for about 4 years. My target weight is around 195lbs.

    ON cycle:4-6 weeks possibly
    CEL H drol- 50/75/75/75/75/75mg depending on sides week to week
    Cycle Assist

    PCT:4-5 weeks
    iForce Reversitol V2
    CEL PCT assist
    Liver Assist xt

    sound good? suggestions?


  2. If you're going to run it for six weeks, maybe you should think about clomid PCT

  3. You can run H-drol for 6 without a Serm. Heck, people have run H-drol with no PCT or just Formex alone and been fine (Not wise, but tis been done). Its very very mild as far a PH goes. Run it for 6 weeks as you outlined

    I used AI Post Cycle Support and Inhibit E for my second H-drol PCT
    First time I ran it I used Inhibit E, Formex, and Cel PCT Assist (bit over the top looking back)

    You dont need both REV and PCT Assist. Pick one (Cel in my opinion) and toss in the Inhibit E at start week three at 2/2/1/1. You'll be fine.
    •   
       


  4. looks good - using reversitol could be a little extreme - inhibit-e or novedex might be a better option for somethin as mild as hdrol but either way it still looks good

  5. Quote Originally Posted by onedumguy View Post
    looks good - using reversitol could be a little extreme - inhibit-e or novedex might be a better option for somethin as mild as hdrol but either way it still looks good
    Why do you think reversitol is extreme? Just curious about your opinion on it. I use it for my PCT along with Nolva.
  

  
 

Similar Forum Threads

  1. Replies: 69
    Last Post: 07-24-2011, 12:40 AM
  2. Replies: 2
    Last Post: 02-03-2010, 04:01 PM
  3. Do you need a serm after a Cyclo bolan (-Drol/H-drol)cycle?
    By Deadlift3 in forum Post Cycle Therapy
    Replies: 9
    Last Post: 10-30-2009, 06:19 PM
  4. Replies: 7
    Last Post: 03-07-2007, 03:44 AM
Log in
Log in