- 08-17-2008, 12:11 PM
Sorry for the dull thread but can someone guide me in the right direction for some info about Human chorionic gonadotropin (HCG).
I would like to know..
how much to take?(i think 250-500IU's a week)
When in the cycle to start this? (i think week 4 of a 12-14weeker)
What is 500IU's measure in mg's, meaning how do i know how much to inject and what type of needle to use?
I'm sure all of these questions have been answered before but whenever i search for "hcg dosage" I just get 250 pages of results for dosage because hcg is a string with only 3 characters.
Any advise or guidance would be much appreciated.
- 08-17-2008, 03:10 PM
If you have a 5000IU vial, add 5ml Bac. water. Then on a 1cc slin pin, each tic is 20iu's. Fill the pin to just between the 2 and the 3 mark. Thats 250iu's. Do that twice a week. Thats the normal protocol for maintaining testicle size and function while on cycle.
Last edited by RedwolfWV; 08-17-2008 at 03:30 PM. Reason: 5 tics to a number. Each tic is 20iu not 10iu
- 08-17-2008, 04:13 PM
08-17-2008, 05:26 PM
29 gauge is just the width of the needle, but yes. Usually, the Bac. water does not come with the HCG. Your supplier may be different. I've heard both Sub Q and IM shots are effective. I'd go SubQ.
09-26-2008, 10:48 AM
Its come time for me to use hcg and i'm clueless as to how to extract only the amount i need and not waste any. I have 5000IU amps and plan on doing 250IU's twice a week. IT came with NaCl and i have 29gauge 1/2" 1/2 cc pinz. Can you break it down for me what i need to do to make this work. Thanks agian for your advise.
09-26-2008, 10:55 AM
09-26-2008, 11:25 AM
09-26-2008, 11:27 AM
Break open both amps. Then with a 25g pin, draw up the 1ml of 'solvent' (which is bacteriostatic water) and inject into the amp with powder. It will mix to a clear solution. Draw this solution up with the same 25g pin and inject into a sterile vial. Be sure to wipe the top of the sterile vial with an alcohol pad first.
Now draw 4 ml of bacteriostatic water (again wiping the top of the bacteriostatic water vial with a alcohol pad before drawing) and inject into the sterile vial. You will now have a 1ml = 1000iu solution. Use slin pins and inject sub-q. With this concentration, 25 on the slin pin equals 250iu's, 50 equals 500iu's etc.
Refrigerate the vial and use as needed. It will last reconsituted for 60 days.
Note: Injected subcutaneous at the navel
09-26-2008, 11:34 AM
09-26-2008, 11:45 AM
Similar Forum Threads
- By ruchit in forum Cycle InfoReplies: 0Last Post: 06-02-2011, 03:48 AM
- By socal101 in forum Weight LossReplies: 1Last Post: 05-03-2008, 02:30 AM
- By deadikated in forum Post Cycle TherapyReplies: 3Last Post: 05-12-2007, 03:28 AM
- By lionman in forum Cycle InfoReplies: 1Last Post: 02-17-2006, 04:51 AM