Homebrew Test E 250mg/ml
- 08-26-2012, 05:39 PM
- 08-27-2012, 12:10 AM
do a google search I remember years ago there was a site out there that had a **** ton of good cookie ideas if you know what i mean
- 08-27-2012, 04:31 PM
You don't need bb with test e... it should dissolve just fine at 250mg/ml without it. 2-5% ba is all you need. Test c I hear does better with bb tho.
I think time with the needle is all you need. The first couple of cycles I did hurt pretty good but it got better over the years.
08-27-2012, 05:19 PM
Here you go brah.
this works like a charm for me
Test E is soluable in oil alone. It needs no additional solvents, but for antimicrobial puposes BA (benzyl alcohol) is used.
Items Needed for a 10 gram conversion:
10 grams test enanthate
0.80ml benzyl alcohol (2% BA)
Syringes 3cc & 5cc or 10cc
20 gauge needles
Mixing vial (or preferably beaker)
Sterile syringe filter
Weigh out 10 grams of hormone into mixing vial or beaker.
Add benzyl alcohol and 26.20cc of oil. (This will leave 5cc oil for later.)
Place on stovetop (electric stove) or frying pan (gas stove) on medium high heat.
Swirl and heat until solution is completely homogeneous and clear. NO hormone "swirls" or visible separation should be left.
Place 20g needle in sterile vial and attach syringe filter.
Place another needle through stopper to relieve pressure
Draw out hormone solution with 5 or 10cc syringe and run it through the syringe filter until all solution is filtered.
Run the addition 5cc of saved oil from step 2 through syringe filter to purge.
This conversion results in 40ml - 250mg/ml sterile solution for injection.
Similar Forum Threads
- By pimpc1972 in forum AnabolicsReplies: 63Last Post: 11-21-2005, 08:27 PM
- By SprtNvolcoM in forum AnabolicsReplies: 3Last Post: 10-20-2005, 11:45 PM
- By pimpc1972 in forum AnabolicsReplies: 0Last Post: 08-09-2005, 12:30 PM
- By badbart in forum AnabolicsReplies: 4Last Post: 08-25-2003, 11:17 PM
- By crazypete in forum AnabolicsReplies: 14Last Post: 02-03-2003, 03:14 PM