is it possible to take cytomel with Mechabol?

[Prodogy]

First off the resaon why I was unable to post this in the Anabolics section was because it would send me to another page where it says the admin wants you to view this page before going to the forum, after I viewed that page I go back and it just kept on sending me there so I said screw it.


So I am 23 years old and I have set my mind on starting a cycle of Mechabol looking something like this:75/75/100/100/100/100.
I will be running cycle assist and milk thistle and for PCT I will have Clomid 100/100/50/50. Obviously my diet will be intense but I am still working that part out.

My question is: is it possible to take T3 ( cytomel) with my first PH cycle and see good gains while seeing a decent amount of fat loss? ahhh yes feel free to add anything onto my mechabol cycle thx!

 

[howwedo107]

Yes it's advisable to run an AAS with T3 unless Your running a super low dose of T3

 

[hvactech]

Im running it like this.
75/100/100/100/100/125 mecha
0/600/600/800/800/800/1000/1000 stano

 

[Prodogy]

hmmm so in my case, mechabol, is it really that potent?

 

[Prodogy]

this is my first cycle, i dunno you think the numbers are too low? Is this your first cycle?

 

[warsteiner]

If it's your first cycle then those doses are fine. Don't use the T3 as mechabol won't be enough to stop the muscle loss. If you are looking to increase fat loss then add in Stano as hvatech is running. Start the Stano at 600mg for the first 2 weeks and then increase to 800mg if you don't have any adverse effects so you would end up with:

Mech - 75/75/100/100/100/100
Stano - 600/600/800/800/800/800

 

[schroedes]

I would find something better than milk thistle

 

[hvactech]

this is my first cycle, i dunno you think the numbers are too low? Is this your first cycle?

Yup first one. Your numbers are fine. As far as potency I can't compare but I'm up 16lbs in week 3.5

 

[howwedo107]

If it's your first cycle then those doses are fine. Don't use the T3 as mechabol won't be enough to stop the muscle loss. If you are looking to increase fat loss then add in Stano as hvatech is running. Start the Stano at 600mg for the first 2 weeks and then increase to 800mg if you don't have any adverse effects so you would end up with:

Mech - 75/75/100/100/100/100
Stano - 600/600/800/800/800/800

This isn't true...look up pyrobatts thread/log on it

 

[Prodogy]

like???? Couldn't find any other product that people would stand by.